Are Tube Buffers for real or even worth it ?

Maybe try a Schiit Saga+ preamp.

Mike

https://www.schiit.com/products/saga-2

I've tried a couple of tube buffers. I hate to agree with the measurementistas but they are just distortion machines. I would look for a tube preamp something like the Schiit Freya+ or even a more expensive tube preamp. 

Figured as much … Thanks guys for the input 

The functional purpose of an active buffer is to improve impedance mismatches by reducing higher impedance inputs to lower impedance outputs.  This can be helpful when driving amplifiers with low input impedances, when using passive volume controls that do not actively buffer the signal, and/or when driving long interconnects.  The effect can be significant, even in cases of unity gain (i.e., no voltage gain between input and output), and the change in sound is sometimes described as having more body, tonal color, and drive.   The buffer can be either fully solid state or tubed.

I use the Hattor Audio Big preamp in passive mode to control the volume of my system and it sounds significantly better to me when followed by my SMc Audio buffer (solid state and unity gain) that is based on their VRE-1 preamp.  I also have the Hattor Audio Tube Active Stage, which is a tube buffer that typically comes with 9dB gain (mine has 6dB).  It is basically a tube buffer stage without a volume control. I have tried the Tortuga Tube Buffer on one of their tours, so I had it in my system for about a week, and I also tried the Purity Audio tubed buffer in my system. 

IMO, and in my system, the Hattor Tube Active Stage sounds very good although it just doesn't provide quite the magic of my SMc Audio buffer, so it is currently sitting in a box.  However, if I didn't have the SMc buffer, I would be perfectly happy to substitute the Hattor after my passive volume control.  

The Hattor Big preamp also comes with an opamp active stage (mine has the NewClassD discrete opamp stage), which can be set to 3/6/9 dB gain.  I bypass the active stage to run the Hattor as a passive into the SMc buffer.   However, I have tried it through the discrete opamp stage and I also find that to be an improvement over running it passively.  Therefore, in ranking buffers (some with low gain) in my system, I would put the solid state SMc Audio buffer first and the Hattor Tube Active Stage second, both of which I would be happy to use.  Third would be the discrete NewClassD opamp stage in the Hattor Big preamp, which I would judge as just a step below the first two.  Finally, I just did not like the sound of the Tortuga or the Purity Audio buffers in my system.

Since you have an active preamp, you probably don't need a buffer.  If you want to change the sound of your system, adding a buffer may be an inefficient way to do that.  I suggest looking into a different preamp, or some type of EQ to deliver the type of sound you want to hear.

Most people just buy the really cheap tube buffers, and then wonder why it's a distortion machine.

@flasd

I had the Zpre3 as my preamp in my main system for quite some time (a great little preamp). I also ran an iFi Micro iTube2 between the Zpre and my amp. The iFi iTube is highly recommended. It’s a bit pricey, but does so much more than most all ‘tube buffers’. It added quite a lot, and has a variety of settings you can use to dial in to taste, or even change on the fly. Check it out. Great piece of equipment.

The ZPre and iFi is now in my bedroom system, and still in use.

@flasd Are Tube Buffers for real or even worth it ?

Is @tubebuffer for real? Only tubebuffer knows. Inside joke, sorry 🤣

Most people just buy the really cheap tube buffers, and then wonder why it's a distortion machine.

Well, that's the point. No need to buy an expensive buffer when you can buy a good preamp.

I have a ZPre3 and compared it to a Schitt Saga with a very good tube in it, volume matched AB comparison I couldn't tell the difference between the two. I was quite surprised actually, the ZPre3 punches way higher than expected. The matching Zamp is a little darling too! Great for starter or second systems. 

Don't you mean tubebluffers?

Best just to buy proper equipment.

Tube buffer reached out to me ....I guess he got banned.   I miss his posts to be honest, they were funny

That’s like “dabbling” in the tube world. I started that way.  When I liked what I heard I invested in a tube preamp. Like @russ69 recommends. Think of it as the “gateway drug” to the tube audio experience. 

I have an upgraded Zamp v3 , with a Schiit Saga with upgraded tube, and it sounds great and fun to play around with...

I have always found that every time I add something in the sound path, I get some good, but also some bad. Either something is muted or something now has more noise. So I try and keep things short and simple. Preamp, amp, speakers, or on my second system it’s integrated, speakers. 
 

All the best.

JD

You have to be careful using the inexpensive tube “buffer” preamps. Some are just straight wires input to output. The tubes only see filament voltage. I have one; only when I pulled off the covers, traced the circuit board, did I find that there was no “tube buffer”.  
 

Another one I have uses a unity gain opamp with only filament voltage to the tubes. 
 

Three times is the charm….The third one I bought actually uses the tubes for unity gain. 
 

And….The whole idea is to add tube harmonics to the sound! So yeah, they are distortion machines!!  LOL!!!!

Save your money for a proper piece of tube equipment...

The TFM-35 is an amazing sounding amp. I found one on eBay new in the box. Even today, its top end is astoundingly smooth even by today's standards.

I ran it through a Don Sachs preamp wih 6SN7s and it was heaven. Doing that and having a dedicated AC line put in helped bass output a good bit. 

Bass output on these amps is extremely flat. But, in many ways, this is a good thing because speaker position and treatment can fix that without things getting boomy.

As mentioned, no need to get tube buffers. Get the best front end you can afford. 

I tried a couple of those cheap Chinese tube buffers you find on eBay and they were no good.  They were starved plate designs - only about 12 volts or so on the plates and op-amps in the circuit doing the work.  Then I tried a Bellari PA555 tube preamp for only $300.  The single 12AX7 is actually functioning with high plate voltage followed by op-amps for a very low output impedance.  This is not a starved plate design.  Let the trolling begin but I am happy with the tube sound it adds.  

I have a Peachtree Audio Grand Integrated X1 amp driving Joseph Audio Profile speakers. The amp has a built in "Bascomb King"  dual tube buffer. The buffer is switch activated (on or off). It looks cool lit up but I can not perceive any sonic improvement to the music when its switched on.

I personally like the Ifi tube buffer II and you want to try a tube buffer I recommend that you do your own research and decide the amount you want spend and dive in.

@stereo_gen 

👍🏼 Folks shouldn’t ‘poo poo’ tube buffers until they actually hear the iFi Micro Tube2 and understand it’s capabilities. It’s an incredible little piece of equipment that can transform your rig, if that is what you are looking for. It’s also very well engineered and does not integrate distortion, it’s really quiet actually. But again, it isn’t cheap vs the crappy ones out there. 

It did it’s job for me quite well until upgrading my preamp by a significant amount. Could I still have it in the chain? Sure, but isn’t really necessary now, for me.

How about the Black Ice FOZ SSX? That’s a tube buffer ++ and it seems that lots of people appreciate it.

@twoleftears

Looking at it, the iFi does more. And at less cost.

Does that iFi have gain?

If you have stereophile class A equipment and are getting a characteristic sound, as you say solid state, rather than add on equipment, check your cables.  Else you will have another component and another cable to add to the problem and your result will be all over the place.

@bumpy48

Does that iFi have gain?

it’s up to you, you have the option of 0 gain, or 9db of gain in either buffer or preamp set-up

+1 @dinov I tried a tube buffer years ago and it was indeed my gateway drug:-) That midrange!

I received this message from tubebuffer.....

"May you have woman of world in tube sock and good sound at fingertip"

Don't know exactly what it means but Ii certainly miss his posts....

oddiofyl

2,005 posts

05-19-2022 at 05:40am 

Tube buffer reached out to me ....I guess he got banned.   I miss his posts to be honest, they were funny

Funny...I said pretty much the same thing and my post was removed..

I think that means behind every good woman, is a stack of electronics....loosely interpreted.

Really like my Black Ice Foz SSX 3D sound expander.  Can’t really explain why but it just sounds better with it.  Bass control and Sound stage expander control is subtle with minor impact.  Have a NOS 60’s Westinghouse long Carbon Plate 12au7 tube in it which is a fantastic tube.

...I've never seen any improvement in buffing tubes, since they're glass....

A little Windex goes a long way to improve the shine, but don't apply during a 'hot sess' with yours....

🙄😏

@oddiofyl .....I think that comment from the @tubebuffer falls into the same category as:

My you live in interesting times....

...you've really ought to get out more.... ;) *L*

I' purchased a new itube2 late March 2018 and it and system has been running 24/7 (fingers crossed) Many pieces (streamers, amps, couple of dacs, wiring, power supplies, TVs, speakers etc) many multiples of its cost have come and some gone but after I heard what it does I've not had a desire to run without it. Sources are Qobuz/Tidal/TV. Everything solid state except for the iTube2 in unity gain. I've enjoyed this amazing piece the last 4 years, hope I didn't just jinx the tube lol.

Why did tubebuffer get banned? His only crime was being hilarious.

Tried one with my SS gear years ago (also to a TFM amp) and the overall effect was zilch, not to mention it had a horrific turn on transient. It didn't give me anything like the wonderful results I got when I bought a Jolida tube pre. I gave the buffer away. All tube now and glad of it.

The iFi Micro iTube2 seems interesting, but they seem to be long gone. Any alternatives?

@pedroeb 

Wow, I had no idea that they discontinued the iTube2. What a shame, but it sure seems to be the case searching around. Incredible little piece of equipment. If you can snag one used, I would still recommend that.