I have T1s as well. Odd about the sound changing when you unplugged it if the sub wasn't working anyway.
Weird
I have a pair of GoldenEar Triton 1 speakers, which have built-in subwoofers. Evidently, the right subwoofer lead fell off the speaker some time ago without my knowledge. I’ve been listening for quite a while with only one subwoofer, really enjoying the sound in blissful ignorance. Everything sounded great including pieces with deep bass such as formidable organ recordings.
Today I discovered the plug out of the wall and plugged it back in. The system immediately closed up, became dull, lacking ambiance. I pulled the plug back out. Sound was wonderful. Everything sounded just right, including the bass which was full and rich.
I’m now listening without the right subwoofer for good.
Weird!
My guess would be you’re sitting in a null created buy how both subs are interacting with your room and each other. Try playing with speaker positioning and your listening position and see if that changes things and/or reversing sub terminals on one speaker if possible. I don’t know how GoldenEar’s customer service is but I’d give them a call too as I’m sure they’ve run into this before. Best of luck. |
Here’s a possibility: From the manual of my preamp “THE LINE STAGE OF THE PV11 INVERTS PHASE OF ALL INPUTS (including phono). If your system has an odd number of inversions, then you must add one phase inversion. THIS IS CONVENIENTLY DONE BY REVERSING THE POSITIVE AND NEGATIVE CONNECTIONS TO YOUR SPEAKERS (be sure to reverse both channels).” I have reversed the positive and negative as indicated. |
I doubt that the inversion of absolute phase has anything to do with your problem. What strikes me as possible though is that with both subs running perhaps you are just getting too much bass and this excess bass is muddying up your upperbass/lower mid range. You have a bass control on the back of each speaker. Play with this for a while, starting out with minimum bass on each speaker and increasing it until the bass can be heard/felt - you might do this one speaker at a time - perhaps because of your set up/room interface only one speakers location is problematic. From your pictures nothing is obvious re room acoustics, etc. (Except they appear to be on the long wall - in my experience speakers usually sound better on a short wall firing down the long dimension of the room. (Think shoe box type concert hall.) |
IMO, the usually level headed Jason is wrong here…do not attempt to disassemble the speakers! Newbee is on the right track. This is about room interaction and too much low bass energy when both active woofers are powered up. Try reducing the levels by a lot on both to see if you can get back to the same overall bass performance with both working as you have with one turned up higher. If you succeed with this you should benefit from lower distortion and more uniform response across seating positions. |
I may have solved the problem but I’m not absolutely sure. I had the left subwoofer plugged into a cheap power hub and the right subwoofer plugged into the wall. Ironically it sounded better with the right power cord (the one plugged into the wall) pulled out. I’m listening now with both plugged in the wall and I THINK it sounds fine. |
Dear @rvpiano : Looking to your speakers specs I read that the subs are controled by DSP software. Now, due that the subs goes to a deep low bass frequency as 13hz could be that you can help you to optimize your room/speakers quality performance levels at your seat position through and external DSP software/unit that can makes measurements about.
Just a possibility to improve what you already have.
Regards and enjoy the MUSIC NOT DISTORTIONS, R. |
I have the grandfather speakers to your GoldenEar's the Definitive Technology Mythos ST's that have powered subwoofers also When l walk by to get a wobbly pop l aways lightly touch the drivers and woofers of both speakers to make sure everthing is working Mine also has seperate volume controls and assuming yours also has the same and more with DSP Double check that everything is set in balance |
Just a thought… With two subs active now you’re probably exciting the room bass nodes and the added bass just overwhelms the rest of the frequency range. I’ve experienced this with the Martin Logan Montis speakers that also feature powered woofers. you can use low frequency test tones to dial in your bass output. |