What's the value in lots of capacitors inside a line stage preamp?

If you have lots of capacitors in a line stage, presumably tube, preamp are primarily for filtering the power supply.  Without going to the trouble of looking up that CJ pre schematic, there shouldn't be more than two coupling caps per channel.....maybe just one.  There's not much to a line stage pre.......

I’m just starting to learn about electric circuits and am fortunate my audio club offered a class including using a meter and oscilloscope . Still trying to figure out what signal generator to buy. Anyway, I’m learning about capacitors here

I am going to hijack a bit here because I have a similar question about DACs.  Take a look at the inside of a Denafrips DAC, they have large arrays of capacitors, what is their purpose in this case? Follow up question, do large arrays of capacitors represent a higher risk of failure or sound degradation given the increase in odds? Not picking on Denafrips BTW, they are just popular and seem to favor this design.

The hallmark of a good preamp is how quiet it is. One of the benefits of capacitors is that they help the preamp from introducing noise into your system. 

conrad-johnson (no caps on the names) have always used very simple circuits and very highly specified parts. Their reliance on film caps, including large value ones is contributes significantly to their product's cost.

Not all capacitors store energy for transients. Those big ones in power supply - yes. They also act as part of filter reducing "ripples" in the DC which remain after AC/DC conversion.

Now, small caps in the amplifier are NOT for power storage. They serve many purposes. For example, isolating one cascade of amplification from another. Capacitor passes AC but not DC. Music is AC (not to be confused with AC mains). Another purpose is to improve stability at high frequencies. Some may not be even part of the amplification and rather operate buttons and such.

@noromance is also right.

I looked at a pic of the inside, and even going back to the PV10, CJ uses capacitors which are just enormous.  Film caps are larger than electrolytic but even among film capacitors there's large and then there's huge. 

Generally, a film cap's size has to do with the uF (microfarads) and the voltage rating.  It looks like CJ is using exotic film caps which for a given uF and voltage are unusually large.  Caps of Unusual Size.  COUS.  (Princess Bride Reference). 

It's also true, IMHO, that for tube preamps the capacitors are often THE sound of the preamp, so it's no wonder for me that CJ is going with exotics.

CJ don’t use (smaller) electrolytic capacitors, hence all the film caps necessary for the required capacitance.

In a tube cap some of the most important caps are the coupling caps.  They block DC but allow the signal to go through.  Because all the signal goes through it their character can be the character of the preamp.

Second are power supply caps.  The higher the value, the lower ESR, and L the better they filter power supply noise.

well you have a full life in front of ya.

start pulling them out one by one and see what happens.