Amp Options - Infinity Kappa 9s

I'd get an older 200wpc Krell instead of any of the above. My go-to amp at home is a Perreaux 2150B (340/680/920wpc@8/4/2ohms) for difficult speaker loads.

older strong class ab solid state amps by top makers should definitely be considered, as mentioned (newer ones too, of course)...

look at other threads here seeking amps for magnepans... same answers for your kappas more or less...

Sanders Magtech.

There is a Classe Audio DR-9 on USAudiomart right now that would be perfect for your Kappa 9s. I have used this exact combo in the past and it is quite good. The DR-9 won’t even break a sweat…

@russ69 

what Russ said. Last,amp you will ever need!

almost unlimited power, the Magtech monoblocks, kicked the MBL Radiostrahler speakers in the pants, as not many,amps will. 
 

Hey Ash, some of those crossover upgrades significantly improve the impedance relative to original, so I would not necessarily compare them to a production unit.

If you have one of those impedance improved crossovers just about any reasonable amp will work. 

I do think you need to broaden your listening horizon though for amps:

• Ayre
• Luxman
• Pass

are alternatives you really should consider.  However, given the unique HF drivers you really should audition them to make sure they are a good match.

Kappa 9s have a min impedance of about 1 ohm.  This is one of the most notoriously difficult speakers of all time to drive.  I had the first edition Kappa 8s which were bad enough at 1.7 ohms.  I blew a lot of fuses. These are worse.  That said, they are actually extremely efficient and you don't need a lot of topline power.  50w into 8 ohms that will double to 1 ohm is far better than 1000w into 8 ohms if it is not stable at 1 ohm.  

Whatever amp you choose needs to be stable to 1 ohm and these speakers are forward so a warmer tonal profile is important.  For new you could look at any of Naim's power amps.  AGD is surprisingly capable at low impedances.  The Tempo is a good choice.  I use it with 2.4ohm Vivid Kayas and it sounds great.  

Can't speak about most of the the other options here.  

Cheers all. Australia poses some challenges in access to a lot. It’s a bit of wait and see what options come up. 
 

I was recommended an ME850 as being able to drive them well. I’ve copied the link to specs below. Could I ask you guys to take a look and give me your thoughts? I will likely upgrade this when other options come up but just looking for something to get me by. It’s supposed to have strong current and doubles output down to 2ohm and below. 
 

https://www.winovate.com.au/me-service-and-repair

I would look around for a used McCormack DNA 500 for the Kappas.