Flush wall plug for power cables?

Thank you bry. Actually my friend, unbeknownst to me has made his own cables and offered to help me out. So we’ll tackle this next weekend. He says it shouldn’t take long.However, I did buy one of the adapters from Voodoo recommended by two left ears.  

jb505,  it is not too difficult a task if the current cord has a non-molded plug end.  The plug will disassemble fairly easy leaving the hot, neutral and ground wires pre-stripped and ready to go back into the new plug.  If it’s a molded plug then you have a bit more prep work to do after cutting off the end, but still not high on the diy difficulty scale.  Several good YouTube videos to watch to get you acclimated to the job.  It looks like you are in the Sacramento area?  I’m sure someone from here that is close by and proficient would offer to assist should you want to go that route.  Heck, if you were near Philly I would gladly do it for free.
Wishing you success on your project

Perfect. Thank you. I’ve never done it but I’ll give it a go.

If you want to do your own ends for tight clearance.

http://www.furutech.com/2015/07/21/11446/

Thanks for all the great recommendations:
I took off my outlet plate and the outlet. I cannot remove the current outlet box to install the recessed box so there is not enough room unless I want to perform a lot of sheetrock work.
I think what I’ll do is buy some flush angled connectors and replace the current ones with these on my cables. Sounds easy enough, but I’ve said that before.
Maybe if I call some cable company’s, like Voodoo, they will custom make me a cable with the flush plug.

I use the Voodoo cable and other right angle adapters.
I spoke to Audioquest, and they said using them shouldn't make any difference as it is metal to metal.
B

Well, not sure which end, but you could use the Wattgate adapter here:

https://www.partsconnexion.com/wattgate-ac-power-schuko-connectors.html

and point the plug in either direction.

You can use an IEC adapter to point your equipment's socket in any desired direction:

https://amzn.to/3oVe65U

I also find these little adapters golden, especially when using wall warts in tight spaces:

https://amzn.to/2M1T86N

https://voodoocable.net/product/ac-power-adapters/

If necessary could you turn your wall plate/receptacle upside down?

their origin is for wall mounted clocks

Thanks Elliot. Great idea. I remember seeing these years ago in an office building I worked in. I completely forgot about them. I’ll have to look and see how much room I have inside the wall for it to fit. It may do the trick.

Thank you noramnce. It’s definitely an option. The only concern is the right angle iec plug. My dac has a sideways iec so the cord would be pointing down. If the cord is flexible enough it may not be an issue. Thanks for the recommendation. 

recessed outlet

https://www.amazon.com/Leviton-688-W-Recessed-Receptacle-Residential/dp/B000U3BVRS/ref=sr_1_3?dchild...

that's a single, more space, they make duplex also