Vintage amplifier specifications

My trusty Sansui AU-999 still delivers the goods. Has specs for delivering 70 watts at 4 ohm load. Drives my DLKs perfectly.

Agree with others. Solid state high current survivors just don’t struggle with speaker loads. My old Crown offers only one set of outputs but lists power specs for 16, 8 and 4 ohm loads.

@unsound 

As an Acoustat 2+2 and Apogee owner… I agree.

There were speakers of this era that really needed amps capable of delivering into low impedances, such as Apogee, Infinity, Thiel, etc..

2 ohm impedance was the threshold for most designs of that vintage.  Even the original NAD 3020 would tolerate 2 ohm until driven hard and smoked.  Unsound is correct about big iron.  Include Yamaha, Accuphase, GAS and Luxman.

Many amps from the 80’s were rated not only into 4 Ohms but sometimes onto 2 Ohms as well. Big iron from Classe’, Krell, Levinson, Rowland, Threshold, etc.. Some even had more rated into lower impedances then than later on.

So two pair of speakers weren't necessarily amp killers in the days of yore so perhaps those old amps were more tolerant with beefier construction than I suspected.

Now days the low impedance load handled by amplifiers are selling points or bragging rights for manufacturers. Who doesn't love an amp that can "double-down"?

I have a vintage Marantz and a vintage Sansui, both stereo receivers. They have main and secondary speaker terminals. This was to have your main speakers and then a remote pair in another location. Most of the units of that era did not have a design that employed multiple impedance outputs ( 4,8,16 ). So they were rated for power at 8 ohms and would state acceptable load 4-16 ohms. Sometimes we’d stack two pairs of speakers and run A and B, or wire two pair in parallel. We were just kids then , but we’d listen for distortion and clipping. New gear has a higher degree of engineering.

Back then most speakers were called 8 ohm so that is all that mattered.

No issue with 2 pairs of speakers for any that I ever owned.

check hifiengine for those specs or audiodatabase for more detailed write-ups of the amplifier(s) in question. most of the time, vintage gear was rated in manuals at power output into 8 ohms / stereo.

I should add that a lot of those old amplifiers, usually integrated had hookups for two sets of speakers which could really drop the total impedance. Maybe a lot of those old units had short lives or they could handle it without issue?