Can a tube amp be damaged by a speaker switch?


Help please from the tech crowd.

I had a room with two systems....one for audio and one for TV. The audio is a Leben tube amp into Altec Valencia speakers. The TV is a Marantz receiver into a group of five budget small speakers. My goal was to use just the Valencia's for both amps because the big Altec's are so much easier to hear dialogue on the tv. I also want to clear up wire clutter in a cramped cabinet. 

My solution was a Luxman AS-55 speaker switch which a very high quality unit designed to allow 3 speakers and one amp, or in reverse setup, three amps and one set of speakers. During set up, I had a question and called the Luxman US manager who picked up the call and was so gracious with his expertise. Great service. The problem is after hearing my questions he said..." we do not recommend using a switch with a tube amp as running tubes without a load can damage the amp...even break it. 

I can use the switch if the the tube amp is turned on only when running into the speakers. The problem with that is the Leben really needs a good half hour to warm up and I would like to do that while watching tv. It will make it cumbersome to switch back and forth between the two. 

Eliminating the Luxman AS-55 switch and just using two sets of speaker wires is an option, but I really do not want to have to plug and unplug the bananas on my Audience cables as that can only hurt them and its a hassle. Im also worried about potential damage to the Altec's with two amps hooked up. 

My question is for the experienced tube users. How much risk am I running if I use the Luxman switch as I intended? Can it really damage the amp or is the Luxman rep exageratting the risk for laibility reasons. What is the potential damage?

 

128x128tamarack4

This is amplifier dependent. Almost all solid state amplifiers are stable into no load, but not all tube amps were.

Check with the vendor.

In _all_ cases you must ensure that the switches used are "break before make." That is, they open completely before making the next connection. The alternative, make before break, can be disastrous for any amplifier.

If you are confidant that you can properly use the correct switch consistently (and you will not have others using the setup) then go for it.

If a speaker becomes disconnected (cat/dog/ferret whatever) while playing music and it's not noticed you have the same damaging scenario - stuff happens.

 

DeKay

 

This is amplifier dependent. Almost all solid state amplifiers are stable into no load, but not all tube amps were.

Check with the vendor.

Yes! Almost all solid state amplifiers are stable at no load, except those without a Zobel network at the output!

https://www.diyaudio.com/community/threads/zobel-or-no-zobel.120748/

In _all_ cases you must ensure that the switches used are "break before make." That is, they open completely before making the next connection. The alternative, make before break, can be disastrous for any amplifier.

Depending on the design, a 3 position MBB (make before break) can be used with a dummy load to ensure that the amplifier is always connected to the load when switching.

https://www.diyaudio.com/community/threads/tube-amp-compatible-a-b-c-switch-design-considerations.389692/

If a speaker becomes disconnected (cat/dog/ferret whatever) while playing music and it's not noticed you have the same damaging scenario - stuff happens.

Installing a 100Ω 5-10W wire wound resistor on each channel of the tube amp output terminal is insurance against accidents.

Buy a modern solid state amp with protection.

I share 1 pair of speakers with 2 amps. I always forget to switch until no skun emerges. I’ve never hurt nothin’.

What you are attempting sounds hazardous to your HiFi budget.

The knowledge and expertise shown by the members of this Forum never ceases to amaze me!  I have no doubt that if added up, the years of experience in this group of Audiogon Members, as a collective, would total in the thousands.

 

Sure, at times there is the very rare member that can be an utterly complete asshat -- but in my years of lurking in the shadows and observing I can honestly say those members are pretty rare.  When they do show up, the Group as a whole is pretty quick at policing their own.  I've learned more about this hobby in the last 7 years from you men and women than I had absorbed in my previous 55 years roaming this Earth.  A heartfelt thanks for not making me feel like a complete idiot when I've asked the occasional question.

 

"What's so funny about Peace, Love, and Understanding?"