Warm Sounding Preamp Suggestions

I can tell you from direct, first hand experience, that in order to fix your problem, you need to get rid of the speakers. I can also tell you that you will definitely get rid of them. The only variable will be how much money spend trying to make them work.

If you are compelled to spend money, start off with a passive line stage. Schitt sells one for around $50. That will allow you to remove the Yamaha receiver as a preamp. Doing that should take a lot of the edge off. Keep in mind that any bandaid components you buy now, will probably not be a good match for whatever speakers you buy when you replace the B&W's.

"I'd also have to disagree with mgreen27; a passive is more likely to be transparent, so if the speakers are a problem (which I don't necessarily believe) that would not help."

I have no issue with you disagreeing with me, but for the OP's sake, I should probably go into a bit more detail. At one time or another, I've owned the entire Matrix series, including the 800, HTM and the Matrix HT package. They all used the same aluminum tweeter, and on every single speaker in the line, the same problem would occur. After a while, the highs just became unbearable. Changing the electronics made some difference, but usually not enough. I know some posters recommended tubes, but I wouldn't buy them in hopes of fixing any problems. Either way, the best results were gotten with solid state electronics. Rowland was the best, followed by Pass. In the end, the only way to get rid of the problem in the highs, is to process the signal heavily or match the speakers to components that are so dull sounding, it ruins the whole sound. When it comes to those old B&W speakers, there's 2 kinds of people. Those who listen to them, and those that can't. Its that simple.

With passives, the transparency argument looks good on paper, but in practice, its a different story. The typical passive customer usually buys one because they can't afford a really good active preamp, and they can't listen to a cheap one. 99% of the time, using a passive takes the edge off the highs. It reduces sibilance. You may be able to make an argument that a really high end passive, like a Placette, may have the transparency to be an issue, but its very expensive and not the norm. The Schitt passive is only $50, and not in that league. He already has a Pass amp, so if the combo doesn't work, very little money is invested. If you can't get the highs under control with a Pass amp and a passive line stage, you need to rethink your system or risk loosing a lot of money.

I know my comments may sound a bit direct or harsh, but in this case, I feel its justified. I know dozens of people who lost money trying to fix B&W speakers, myself included.   

Dastro

What a difference that box made.

It’s a great design, and was far ahead of its time allowing for full range, and in rooms that do not support it.

You are basically turning the 801 matrix’ massive woofer box into an EQ’ed subwoofer with one setting ...a factory designed one ..... settings on the BAF being different for each particular 800 - 805 matrix model.

The additional and maybe even greater benefit imo, is that the EQ boost allows the ohms requirement to remain in the 6 ohms range on 100 hz and less ..... not as taxing on an amplifier.