Speakers better without subwoofers? Crossover and synchronization issues? What do you do


 

I bought main speakers 25 years ago, spkrs seemed to have much larger bass drivers back then,  and nowadays subwoofers are a staple in audio systems, while bass drivers have tended to get smaller in diameter on main speakers, why is this?

Wouldnt it  be better to have a larger bass driver in a main speaker   rather than having timing issues with a pair of subwoofers? Also seems crossover designs might allow for a better sounding experience if they are part of a main speaker. I do have a Single subwoofer that I use to vibrate the room which works pretty well watching movies, simulating tank movement is really cool although don't use it in two channel listening at this point since it's older.

 

emergingsoul

The reason bass drivers have gotten smaller is they are much more capable (longer throw) and faster (less overhang). Huge drives have inertia and are not nearly as articulate. Lots of folks have subwoofers… I suspect very often they are not adding to accuracy but over accentuating the lower bass.

I have gone to a number of homes and immediately turned the subs almost off… and the sound improved dramatically. I got rid of my sub woofers in my audio system a number of years ago. My speakers are flat to 28hz. They sound perfect, perfectly coherent. No integration issues. But then I don’t listen to hip hop.

Proper subwoofer adjustment is key, and possibly rare. There are pros and cons with everything in audio, including woofer size, mass, excursion, etc. Many, many that I’ve heard are used as the main attraction, which is fine if that’s what you like, but it’s not natural to acoustic instruments.

There are certain ranges that some woofers do well, and some that they don’t. The trick is trying to optimize what you have. Most subwoofers I’ve heard are set too loud relative to the output of the mains, and in many cases the low pass crossover frequency is set too high. The male vocal range can dip below 70 hz, which is not the best range for most subwoofers to operate in, yet many do. I try not to feature the sub, but use it only to augment what my main speakers do in the lowest octave or so. IME, subs work better set below 60hz, and when they’re barely noticeable except for passages that have deep heavy bass.

the subs in a two channel system shouldn't rock, vibrate, shock, etc. They should blend in, as if they didn't exists. When dialed in correctly they add another layer to the soundstage, and depth and punch to e.g. the drum

The DSP in current subs makes the placement issues a lot easier than in the past.  I like SVS because their subs are musical.  It isn’t the boom factor, but the way they bring out low level detail in quiet orchestral passages, and expand the sound stage 

@emergingsoul Yup those old speakers were something else. I grew up with my father's Bozaks. The problem is those large enclosures resonate like crazy. They are musical instruments. The bass drivers of the day were not capable of long excursion with any degree of linearity. Modern speakers use smaller enclosures and smaller woofers in multiples. The low bass is separated out and sent to subwoofers which have very specialized drivers able to push out huge bass in smaller less resonant enclosures. 

Many systems are better off without subwoofers, I would venture to say most because the subs are poorly integrated and/or resonate and give themselves away.  In a great system with properly integrated subs you would never know the subs were there until you shut them off.  If you are reading the specs of your speaker, flat to 28 Hz is at one meter. That is a far cry from flat at 12 feet. Not only this but getting realistic bass in a normal size room requires a 10 dB boost at 20 Hz starting at 100 Hz gradually upsloping. Every system can benefit from subwoofers but to do it right requires digital bass management which most people are not using. Integrating subwoofers with an analog low pass filter will only create a result that a seasoned audiophile will cringe at.  

@mijostyn 

 

the Sonos Faber il cremonese have 2 extra bass drivers Incorporated into their mains where the crossover is set at below 80. I like this idea rather than introducing a separate subwoofer, placement issues aside, if that's a concern.  Maybe it has a lot of value because it takes pressure off other bass drivers, with a crossover set at above 80.

 

 

@emergingsoul I do believe that is a Franco Serblin stunt. What they are doing is relieving the front woofers from having to make long excursions which lowers their distortion dramatically. This is what subwoofers do when used with a two way crossover and not just the low pass filter installed in most subwoofers. These added woofers are almost subwoofers. That speaker is capable of prodigious volume and they would normally require at least two 15" subwoofers to keep up in terms of getting down to 20 Hz with the required boost. You could probably EQ the Fabers to make that kind of boost, but you would not be able to play the system very loud. So, the internalized low frequency woofer is more a solution to lowering distortion than it is for extended and powerful low frequency reproduction. I have a friend who has Franco Serblin K'temas that do the same thing and they are wonderful sounding loudspeakers. Franco eventually left Sonus Faber to start his own company. He passed away not long ago. Do the K'temas require subwoofers? This depends on your view of the universe. My friend says no. I say yes, but I would cross much lower than I usually do. Large spaces breath at low frequencies. Even with your eyes closed you can tell you are in a large space. You can feel it. Many recordings of live performances have enough of that information present to fool you into thinking you are in a large space, if your system can reproduce it. My system is down 6 dB at 16 Hz, The subsonic filter is at 10 Hz 14th order. From a simplicity perspective my friend's solution is superior. It is much easier to screw up a system with subwoofers than it is to make one better and most subwoofers are not what I would call high fidelity. Have a look at this https://imgur.com/gallery/building-resonance-free-subwoofers-dOTF3cS

@mijostyn 

Impressive reply. And very helpful.

Curious that you cannot biwire,biamp ktemas which is sad. They don't want you messing around back there with their crossovers.  

I did look at the ktemas, very very heavy not terribly expensive in the scheme of things.

The friend drives his K'temas with a Bricasti Design M25 and I have not heard a dynamic speaker sound better. In this regard I would not change a thing. Up against speakers like Magicos and Wilsons they are dirt cheap and an amazing value. I also think they are cool looking. I also would not add a subwoofer unless you were going to do it right, which means a digital processor and two of the best DACs