2. cables
  3. 161812-85733

HOW DO YOU CLEAN YOUR CABLE JACKETS?

I've searched everywhere and there are lots of people discussing contact cleaning but no one mentions the dusty dirty jackets especially on fabric jacketed cables like Audioquest etc. I used a hand vacuum cleaner with an edge attachment, cut a radius notch in the end, then used painters tape on the edges to prevent staging the threads of the fabric. As I re install the cables, I'm considering expandable loom to protect them from dust in the future. Loom is inexpensive and disposable. Anyone else have a better idea?
oldschool1
11 responses Add your response
roxy54's avatar
roxy54
7,979 posts
 
As I have discovered, this is why homemade or reasonably priced cable lifters are very useful..
ericsch
752 posts
 
That's what I said. Oldschool1 was talking about mud? Time to change the furnace filters?


geof3
1,129 posts
 
Run them through a damp, not wet, clean cloth. Cleans them right up. 
oldschool1 OP
45 posts
 
There’s a great idea! I’ve always wanted an air compressor... lol
Much more effective than the vacuum cleaner, and has so many more uses! Time to go to Harbor Freight before I put the whole thing back together as soon as my amp gets back from service. The right channel just went out on my Anthem P5.
theo's avatar
theo
2,684 posts
 
How about compressed air, if you have an air compressor available. Canned air wouldn’t be enough, in my opinion.
soix
9,456 posts
 
Sounds like a great excuse for a cable upgrade!
oldschool1 OP
45 posts
 
The attachment I used was the crevice tool. Having an angled edge worked well. Using a Dremel, I cut a half circle big enough for the largest cable. Using a finger to bridge over the tools end I could draw the cable through. Worked pretty good. I was hoping someone had a better idea.
millercarbon's avatar
millercarbon
12,531 posts
 
Well there's always the washing machine. Delicates cycle. Line dry.

Seriously, I would remove the brush, use the crevice tool, and vacuum. Then if you want it to look nice use a fine quality brush like for shoe polishing, or the vacuum brush attachment, and everyone's favorite long smooth strokes to finish it off.
oldschool1 OP
45 posts
 
With three years of dust, I don’t believe a lint roller would do the trick, especially with dust below the top fibers. A damp microfiber could turn dust into mud. Fabric cable jackets being very porous dust or mud might get left behind. Good ideas though.
any other ideas?
ericsch
752 posts
 
Microfiber cloth lightly dampened with distilled water.
dill
2,524 posts
 
Use a lint roller.
Log in to respond
More to discover
80x80
Transparent Audio Reference XL
80x80
Synergistic Research Galileo SX 3 Meter Ethernet / Digital
80x80
Purist Audio Design 35th Anniversary USB