Connecting dual subs with speakon connectors


Hi all :)

I want to connect two subs (bk electronics XLS200-DF MK2) with the high level lead speakon cables to my poweramp. Now my question is, can I connect the red white(or yellow) amd black cables of both speakon cables to the correct speaker outputs on the poweramp or should the cables to the two subwoofers not come into contact for some reason?

Right now I am using a Musical Fidelity m6prx power amp but I will exchange it for an ayon triton power amp in the near future.

 

Thank you for any and all help.

benkenobi92

Thank you everyone! I have now connected them as advised by @noromance and many others. It works and sounds perfectly. Thank you for all your inputs.

@lalitk 

YES.

Actually, I forgot to mention that I feed both subs a stereo signal instead of a left sub and a right sub. So both setups are correct. Depending on the way you use your 2 subs.

Ok, I guess this is a thing. My bad. So, why would you want to do this. What is the advantage?

@jayctoy

Yes, one sub connected to the left and second sub connected to right outputs (binding post) of the amp to each sub’s high level input via speakon connector.

“Just twist the same colors (from both subs) together and connect as the manual describes (for a single sub).”

NO!!!🤦‍♂️

The correct way to connect two subs with high level input would be what @noromance said, if you find the gain is too high then float the yellow wire.

Red and yellow (together) to + / black to – on each channel on the power amp.”

  • No problem. Just twist the same colors (from both subs) together and connect as the manual describes (for a single sub). I am running 2 subs this way. Works perfectly.

Yes

R*L = +    f L channel

B  =   ---       

Hook one to L, The other to R. Good to go. You may have to float your black IF you get a hum.              

 

@ghdprentice  the high level input is the reconended input for this subwoofer.

@ditusa thank you very much. Sadly the manual has no mention of how to connect two subwoofers...

@noromance ​​​+ @artemus_5 : Thank you very much, I think this is what I was looking for. This makes a lot if sense as the yellow and red wires go to the two positive (red) speaker outputs when connecting one subwoofer. Just to clarify, I would connect one subwoofer with red and yellow to the positive speaker out of the left channel and black to the negative speaker out of the left channel and the other subwoofer with red and yellow to the positive speaker out of th right channel and black to the negative speaker out of the right channel?

Thank you very much for your help!

+1 @noromance 

That is Rel's way of hookup  But he better make sure that the red & yellow are both positive for his B&K's. I'd think so but but i never underestimate the marketing depts ability to make a different color as - such as yellow. Marketing can then say that the yellow wire is more appropriate for ground due to its molecular proclivities towards the negative side This would obviously be better that the way abc-xyz does it which tends to  slow the signals and therefore blur the VooDoo dust to the point of human incapacitation.

Red and yellow (together) to + / black to – on each channel on the power amp.

@ghdprentice The high level input (100k impedence) on the subs is designed to be connected to the speaker outs on the power amp. 

No, stop. Subwoofers have their own amplifiers. You want to connect it to your preamp. This sub has a 275 watt amplifier in it. You want to use that.