Bookshelf speakers with a tube amp?


Hi. 
I just sold my Klipsch Fortes. I have a Cary Rocket 88 (40 WPC). I’m now pairing it with Boston RC8 speakers (25-125 W). So far, I’m pleased, because I have a wonderful SVS Micro 3000 sub. (500 W)
  I have an option to grab Solid State amps: Marantz 2226 B (26 WPC) or a Pioneer Sx-7 (60 WPC)… I wonder about whether I should see or HEAR enough credible difference, either gained or lost, if I switch to solid state from the Cary. I was surprised at what I heard in clarity and midrange in these little Thrift Store Boston RC8’s. But my question lies in the tube distortion sound, vs. solid state power. I think I’ve heard it said that tube watt ratings, though lower, play with power ABOVE rated WPC. Right now, I like the Triode mode in the Cary, at (26 WPC)… better sound than UL, yet less power. Klipsch Forte are 95 db sensitivity, really MADE for tube one would imagine, yet I guess if the Bostons play without distortion (off the Cary), then is it more of a strain on the Cary to play it closer to full blast… to run bookshelf speakers needing more power?

what thoughts are appreciated…

128x128moose89

+1Russ69. Last night I listened to my Aric Audio Transcend amp with a quad of KT120s running in ultralinear producing 40wpc driving my Esoteric MG10s. The MGs are a 6ohm speaker that drops below 4 ohms at one point in the frequency range, also  rated at 87dB sensitive( experience tells me this is a reasonable measure). I used the 4 ohm tap on the amp.

I felt this combo a better experience than using my Pass XA25 in same system.

Fritz 2-way speakers have crossovers especially designed to work well with tubes.

I use Reference 3A de Capos with my 4 watt Decware tube amp.  lovely sound not screaming loud but loud enough   92db eff. detailed

Yep. I’m blown away right now. This Cary is just so sweet in Triode mode with these Boston speakers, a great Henry Kloss, (Advent) engineer. I didn’t notice the UL/TRIODE switched difference with the Forte… but to think these bookshelf pair cost me only $35… definitely blessed!

I really love the Mancave sound room now… got a remote for my Node…streaming heaven on Preset buttons on the remote!

I did a little experiment a few years ago....I set up a pair of Klipsch KG 1.5 in my main set up.   40 watts of Quicksilver EL34 goodness and they sounded great.   This bolstered my believe that even modest speakers sound better, maybe too good to believe with quality electronics.   The 15 watt Technics receiver did an OK job but with those amps and my CJ pre they sounded better than a little speaker has a right to.  Shortly after that I picked up a pair of Heresy III to replace the Revel 106 I was using .  Used them about 4 years and bought Forte IV...  I went in the other direction but I would definitely stick with the Cary , that was one of the best amps they made .   Good small speakers can sound good with a great amp

As much as I love vintage Marantz receivers, they were not built to be used as separate components. Their strength lies in the fact that the preamp and amp are built to be integrated. On their own they don't stand up to a dedicated preamp or amp.

I think my Marantz 2226 B should be the preamp then. It has that capability.

You will not hear how good the Rocket88 is until it's matched with a good preamp. For the budget minded the Topping Pre90 might get you there. 

I think my Marantz 2226 B should be the preamp then. It has that capability. 

I’ve been real happy with Bluesound Node DAC

Budget a preamp for your future upgrade and loudspeakers. Keep the Rocket88.  

I’ve been real happy with Bluesound Node DAC, and it fulfills all PreAmp aspects over my iPhone through an App. 

Run the Rocket 88, I prefer to run in UL mode, especially if you are short on power. Try the 4 ohm setting.

What preamp are you using?