imhififan
Responses from imhififan
| Need help with system connection IME, Goldpoint is very good. http://www.goldpt.com/sw2x.html | |
| Need help with system connection A line level A/B switcher connect to Simaudio W5 input and you can select Benchmark DAC1 or Marantz AV7701 as a preamp. http://www.goldpt.com/sw2x.html | |
| Please help! Tube amp issue @jetter, OP solved the problem by swapping the wires of output transformer on primary side as suggested. https://www.diyaudio.com/forums/tubes-valves/330414-please-help-tube-amp-issue.html | |
| AV7704 Audyssey https://audyssey.zendesk.com/hc/en-us/articles/212341603--Phase-error | |
| Attention Manufacturers: What I want is a TINY HT processor! https://usa.denon.com/us/heos/heos-avr | |
| Thiel cs2.4 upgrade to cs 2.4 se Hi guys, i intend to get claritycap csa 10 ohm + 3.9ohm to replace the original caps 13ohm +1ohm and claritycap csa 10ohm +18ohm to replace 27ohm + 1ohm original caps. Do i need to change or remove any resistors? I think you mean 10uF+3.9uF an... | |
| Recommend powered center / surround combo that won't break the bank? Denon HEOS system? https://usa.denon.com/us/heos/heos-avr | |
| Tube tester: Orange VT 1000 @tsbel, great info, thanks! | |
| TAD 150 Signature preamp remote sensor out? I asked him to see if there's a way to bypass the controller, switch modes manually, and wire up a separate remote to the volume pot-motor. He's going to look into it...Ask him if he can make use of this kit: https://www.ebay.com/itm/Assembled... | |
| Powering nine home speakers Best to have each speaker with its dedicated amplification so you can adjust each channel level for evenly distribution. | |
| Powering nine home speakers I thought you have a HT setup using the onkyo in a dedicated theater room and want to switch the music to your living room? | |
| Powering nine home speakers Since you have the onkyo receiver with 7 channel of power amp, and a stereo amp (Yamaha R-S202), why not make full use of all 9 channel of amplification! Just connect 7 of the ceiling speakers to the onkyo speaker terminals via a/b speaker switch... | |
| CABLE FROM RCA TO AT&T FIBER OPTIC ??????????? Digital Coaxial (RCA) Audio to S/PDIF (Toslink) Digital Optical ? https://www.amazon.com/Digital-Coaxial-Toslink-Optical-Converter/dp/B001622FL8 | |
| Does impedance of a speaker change when one bi-amps? IMO, parametric equalizer pair with active crossover can make a huge improvement! | |
| Setting up 2 power amplifiers to setup at once help? Might consider using the 2801 to power the highs for your speakers and the 'sub' out from the 2801 into the Yamaha to power the lows. Imo, it's not a good idea, you don't want to use a active crossover in the receiver and the passive crossover... |