Limiting a full range driver


My speakers, Reference 3A NEFES, have 2 full range 8" drivers. My question; is it better to limit the frequencies to 100 Hz and higher. My thinking is that the lower, sub 100 Hz signals interfere with the midrange too much with their larger cone movements. Or, is there no benefit to cutting out these frequencies?

koestner

I still don’t  understand why a single driver to handle all of the frequencies would be a desirable thing given the potential problems that arise. Is the lack of a cross over the only reason? It seems like a well built 3 way would be the way to go. 
 

Happy listening all! 

Interesting speakers.

Dual 8’s are the equivilant of an (approximate) single 11" woofer. That’s a fair amount of "meat" and should produce a reasonable amount of bass at moderate levels without getting too "weird" in the midrange. Having dual motors and smaller cones (dual 8" vs 11") gives you advantages in control and resolution. I think this is a valid design that should yield very good sonic results. (Some reviewers agree). I’d make sure your vertical listening position height (ears) are dead on with the tweeter location. Otherwise, the "point source" benefit of the speaker will be compromised

To high pass, or not to high pass, may be a product of experimentation. There’s credible sub manufacturers out there that INSIST that you run the mains full range. I’ve experimented with this a bit, and can’t disagree with their recommendations. I think it’s speaker dependent, and volume dependent. And, yes, room dependent.

Before you start throwing money at fancy crossover schemes, you might want to just toss a quality sub (or, two, or three...) in the room and see/hear what happens. You may also find that the additional sound pressure created in the room by the powered sub(s) negates, to some degree, the need to put the pedal to the metal on the volume control, which will reduce some stress on the mains, thus cleaning up everything.

Nice speakers by the way. Well done.

Thank you for the recent posts, but deeper in this thread I did say that I am using subs. They are Velodyne DD15's that both broke (electronics problems) so I ran drivers to banana plugs that I installed on the plate amps. Now I use a stereo Crown Class D amp to power them. The amp is about 750 WPC into 4 Ohm in each channel. The amp has a built in low pass that I have set at 24 db/oct. and at 74 Hz.

"but deeper in this thread I did say that I am using subs."

Yep, there it is.  Got me.