What about wall plate connections?

Nope, a fancy wall plate is not going to improve the sound. You are already using a high quality Ethernet cable and taken care of the possible noise by inserting a very good passive filter in the signal path. Just make sure the connection is secure at wall plate. 

Hi @lalitk !  I asked  for the Supra  cable custom terminated with a female end on one end. I would just stick it through a round hole in the plate and directly connected to my Muon cable. Can’t be worse right? And takes a couple of cheap contacts out of the line. I am surprised to not see a bevy of products with enhanced connectors for plates like this. Thanks for your response always good to hear from you !

@fastfreight

I understand now what you are trying to do. There are couple of ways to keep your Muon Ethernet cable. You can buy a cheap Ethernet coupler (may degrade the sound) or buy a Ethernet Isolator.
https://www.amazon.com/EverStar-Metallic-EN60601-1-Healthcare-Believing/dp/B0B96KBLWK/ref=sr_1_2?crid=2VPDXD5HBAAFL&keywords=ethernet+isolator&qid=1666181231&qu=eyJxc2MiOiIzLjI1IiwicXNhIjoiMi43NiIsInFzcCI6IjIuMTMifQ%3D%3D&sprefix=Ethernet+isola%2Caps%2C747&sr=8-2&ufe=app_do%3Aamzn1.fos.18ed3cb5-28d5-4975-8bc7-93deae8f9840

Alternatively, you can go direct into Muon filter with Supra. I believe Rich mentioned  to me that the LAN after Muon / ENO filter is more impactful than the one before entering the filter assembly.

MUON / ENO Filter: open RJ 45  terminal.

MION / ENO FILTER  SYSTEM comes with extra gucci Ethernet cable to complete ’ the improvement.

so I Do want at to use this Muon male- male cable.

I am aware of the 200 Network Acoustics Ethernet couplers.  I need two at the switch end.

i really should have gotten female - fealr Supra Wired’s,  but don’t see them factory terminated.   For all I do I should make my own!

 Thanks, Ken

Well, I don't know how cheap they are but if you are going with that you should include a shielded jack. The female connector has a metal jacket instead of plastic to maintain the integrity of the shield.

Can you point me?

thanks!

I decided to just go ahead and use a JCAT coupler.  Easy to pop out the cheap wall plate part and ran the Supra cable through the wall (on both ends).

“JCAT coupler”
@fastfreight 

Can you please provide the link?