melody 2a3 mono amps

Anyone know anything about AM Melody h6550 integrated? Just picked one up for the den. Tunes look old a little burnt they say made in Australia.  Still sounds and works great  just wondering what I should use in it. The power tunes are kt88 electro harmonic. They look pretty new. Just can't find any information about it.  Thanks 

What they said. More power needed. 2A3 amps need big drivers or horns. I'd bet they're 90dB.

Paradigms while fairly efficient are not an easy load. IMO and IME you are waaay underpowered for those speakers. What version are they

i have 2x melody 2a3 amps ...i run are paradigm studio100

I see the problem. You have no bass. Throw a good sub (or two) on your system, it will be a new world. 

A couple thoughts - 

I am not familiar with your speakers. I run 93 dB efficient JBL monitors with less than 8 watts per speaker and they have loads of bass, but they are using 15 inch woofers. 

I think the suggestion to play around with the positioning of the speakers is a good place to start.

Good luck and please share your progress on your journey.

I don't think the amps are a good match for your speakers. You need more efficient speakers for them to perform at their best. See the link below for some info on the amps:

Review

ty J........i don't think u like tubes ?i'm still deciding . i picked up these pieces used but  have not had success. cost me 4000Cd 7 months ago. reason why was because my beloved creek5350se  bit the dust... caps i think. need a good repiar shop . im in bc canada and dont know where to send it for repair, would u know of a respectful repair shop?

Sounds like the OPT (output transformers) are rolling off the bass and treble. A common problem with tube amps - both single-end and push-pull. Good big iron is expensive! Witness the Carver 275 amp with the small crappy transformers! For its high price a waste of money! I suggest getting a way more powerful amp - tube or transistor. A Crown XLS 1002 (200 wpc) would be a good match for the Paradigms. There is one for sale now on eBay for about $400.

You are at the low range of the power needs of the speaker. Try moving the speakers closer to a wall or corner and see if that helps. If not, you might need more power, especially if you have a large room. Make sure the speaker cables are fastened to the lower posts of the four on the speaker. You have excellent amps, I would look to pair them with speakers from ZU or similar for best results.