I would suggest a pair of Tannoy 15 inch monitor gold or hpd in lancaster cabinets or bigger and also as for the integrated I have been using a Korean Emille Ki-40l with a pair of hpd and is a good match. They fill my room which has 15 foot ceilings and is about 30 foot c 60 foot and reward you if you are sitting close at low volume or just mooching about doing stuff. (The Ki-40l is for sale at £2750 and is 240v) hope that helps.
Integrated tube amplifier for large speakers
Hello,
Looking for some advice on Tubes and Floor standing Speakers.
Although I liked my system, now I am forced to upgrade my speakers (Bowers & Wilkins 705 monitors) and probably my Jolida JD 202 integrated tube amplifier due new room’s dimensions. I moved from a small space to a very large 950 sqft loft with 15 ft ceilings.
So I looked up for options within my budget and came across the following:
-Bowers & Wilkins CM9 (89 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier:30-200w
-Focal Aria 926 (91.5 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier: 40-250w
-Sonus Faber Venere 3.0 (90 db Sensitivity) 6 Ohms Nominal Impedence. Recommended Amplifier:40-300w
*I am aware that speakers’ impedance constantly fluctuates and that the newer B&W 700 series behaves more like 4 ohms, probably the CM series did to, but I am not sure how good small tube amps are at handling these impedences.
Jolida states that the JD 202 Integrate amp has a Rated Output Power of 40 W per channel at 8 ohms, 30Hz to 80KHz and a Maximum Power Output of 60 W per channel at 8 ohms, 1KHz.
Wrote Focal and they said it shouldn’t be a problem, but.....
Would this humble amp be able to run those speakers?
On paper it seems that it barely does.
I don’t listen to music at loud levels, however, I want to make sure I am not pushing the small amp to its limits.
How many watts per channel do you think are needed to power those large speakers and would you have any recommendations for integrated tube amplifier below $1500-2000 (used) ?
Your advise will be greatly appreciated,
Thank you,
Josep
Looking for some advice on Tubes and Floor standing Speakers.
Although I liked my system, now I am forced to upgrade my speakers (Bowers & Wilkins 705 monitors) and probably my Jolida JD 202 integrated tube amplifier due new room’s dimensions. I moved from a small space to a very large 950 sqft loft with 15 ft ceilings.
So I looked up for options within my budget and came across the following:
-Bowers & Wilkins CM9 (89 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier:30-200w
-Focal Aria 926 (91.5 db Sesitivity) 8 Ohms Nominal Impedence. Recommended Amplifier: 40-250w
-Sonus Faber Venere 3.0 (90 db Sensitivity) 6 Ohms Nominal Impedence. Recommended Amplifier:40-300w
*I am aware that speakers’ impedance constantly fluctuates and that the newer B&W 700 series behaves more like 4 ohms, probably the CM series did to, but I am not sure how good small tube amps are at handling these impedences.
Jolida states that the JD 202 Integrate amp has a Rated Output Power of 40 W per channel at 8 ohms, 30Hz to 80KHz and a Maximum Power Output of 60 W per channel at 8 ohms, 1KHz.
Wrote Focal and they said it shouldn’t be a problem, but.....
Would this humble amp be able to run those speakers?
On paper it seems that it barely does.
I don’t listen to music at loud levels, however, I want to make sure I am not pushing the small amp to its limits.
How many watts per channel do you think are needed to power those large speakers and would you have any recommendations for integrated tube amplifier below $1500-2000 (used) ?
Your advise will be greatly appreciated,
Thank you,
Josep
16 responses Add your response
I run a pair of Yamaha NS-1000s with a little Jolida Sj502a with Kt120s and vintage bugleboy imput stage. Sounds wonderful. That being said you can prob run just about anything you want with that amp. It can be had for less than a grand. Edit: I do recommend changing the selection switch and pots out for better quality. Also beefing up the power board with better caps and resistors will help running the KT120s, but the 6550s run good too, if you choose to stay that route. |
I have a 14’ ceiling and it sounds freaking fantastic with Vandersteen Rudy Van Gelder had vaulted ceilings in his coveted and world famous recording studio !!!!! anyway always, always try out the various transformer taps for best sound.... trust your ears unless you have a short ( emphasis on YOU ! ) between the headsets... some fantastic tube values right now: Rogue VTL Quicksilver Atmasphere ARC and of course Bedini. |
You need to put away the specs and step back for a second. I agree with the speaker first approach. there are a ton of options depending on what you want to spend. There are many speakers that will work great with tubes, but also with SS if you want to switch. I have to say that I personally love the Vandersteen's. They are outstanding with both tubes and SS adn they will play plenty loud with any of the amps listed so far. Another suggesting for an integrated amp is a SS one. The smaller Belles integrated amp is under 2k I believe. Right now, it's my favorite inexpensive integrated amp (they are about to release their monster integrated). Most Vandy dealers sell those Rogue amps as they are outstanding values for tubes. There is a reason that Vandersteen's are the best selling high end speaker of all time (the 2's). I'd make sure to give those a try along with the similarly priced Focal's, B&W's or anything else. |
Good morning folks!I have been looking and in a similar situation, I am considering the Jolida S3502 ($1700) integrated and maybe a pair of KT88's or 120's and the Tekton Design Pendragons ($2000) or Enzo's at 96-98 dB http://www.tektondesign.com/pendragon.htmlThe 3502S should have zero problems riving the TD's and quite capable of filling your space! |
I would buy the speakers first and see how well your Jolida drives them. As far as which taps to use try both to see which gives you the better sound. If you decide to change out the amp you might want to research a Cary SLI-80. There are a couple of used units for sale on this site within your budget (no affiliation). It offers a lot of flexibility with regard to tube type and can switch from triode to ultralinear on the fly. Plus Cary offers part upgrades like capacitors and the like to improve performance. All in all a fun amp to play with and won't break the bank. Chuck |
Buy a used NYAL Moscode 150. It's a hybrid amp using a four tube front end driving a MOSFET output stage. 75 wpc at 8 ohms - considerably more at 4 ohms! Designed by George Kaye and built here in the USA. The best of both worlds - tubes for input and voltage gain, transistors for current and power! I have one myself! |
mamifero, Why not get the set of speakers first, and see if you even need a different amp. As far as the 15' ceiling, that's tough. I have a vaulted ceiling that's about 15', and after trying for years to "get it right" and pissing off my wife, I finally made a room in the basement. All the best. JD |
The first thing that I will mention is you have a large space to fill. So, you are going to need power and most likely should section off a listening area in your loft. Those 15 ft. ceilings will make it tough to control the soundstage from your system. You’ll need to get higher SPL’s from the speakers than in your other space. I didn’t check any of your specs, but under ideal circumstances the 40 watt amp might be enough, but the size of your space is going to require higher power. |