Can LM224 be used to process an AC signal?

To use LM224 to process an AC signal (plus or minus 500mv), the op-amp is powered by a single power supply. Is this possible? Will the op-amp be burned?
Introduction of LM224: https://www.utmel.com/components/lm224-operational-amplifier-application-pinout-and-datasheet?id=509

roseljr09-16-2021 3:58am

erik_squires Details Discussions Posts This discussion Message User 16,057 posts 09-16-2021 at 05:19pm Copy Comment URL Report Comment Edit Delete DIY audio is best, but an op amp fed by a single voltage rail has to be AC coupled. That is, you put a cap before and afterwards. Hobbyists usually use dual op amps in 8 pin DIP configurations though. Easy to swap out!
fiesta75 Details Discussions Posts This discussion Message User 1,378 posts 09-16-2021 at 03:22pm Copy Comment URL Report Comment Edit Delete Yes it can be. Use the highest supply voltage that you can for best performance. What output level are you wanting to obtain?
abraxalito Details Discussions Posts This discussion Message User 93 posts 09-16-2021 at 10:30am Copy Comment URL Report Comment Edit Delete To have an LM324 (the more well-known variant of this chip) handle an AC signal its necessary to have either two power rails (positive and negative) or a mid-rail generator circuit. Better to ask this question on DIYAudio I reckon.