Can LM224 be used to process an AC signal?

To use LM224 to process an AC signal (plus or minus 500mv), the op-amp is powered by a single power supply. Is this possible? Will the op-amp be burned?
Introduction of LM224: https://www.utmel.com/components/lm224-operational-amplifier-application-pinout-and-datasheet?id=509

roseljr09-16-2021 3:58am

erik_squires Details Discussions Posts This discussion Message User 16,810 posts 09-16-2021 at 05:19pm Copy Comment URL Report Comment Edit Delete DIY audio is best, but an op amp fed by a single voltage rail has to be AC coupled. That is, you put a cap before and afterwards. Hobbyists usually use dual op amps in 8 pin DIP configurations though. Easy to swap out!