Luxman, D'Agostino, Ayre are all amps I'd recommend you listen to.
20 responses Add your response
Listen for yourself and judge the performance. Unfortunately, like many many speakers, the Wilson’s have an impedance dip in the 100-150Hz range down to 3 Ohms. https://www.stereophile.com/content/wilson-audio-specialties-yvette-loudspeaker-measurements What does this mean? It means that the place to listen for amp differences is going to be in this range. Some stereo amps may perform better than some mono, so listen to see if there’s any difference, and if it’s worth the monetary outlay. Best, E |
Post removed |
Op when you say headroom what does that mean exactly, are you clipping the amp? Or are you looking for a more lively sound? The Pass amplifiers are a little dark sounding so depending on your setup you may be looking for a more exciting sound then you are getting now. You may be turning up the system to hear more detail so you need to evaluate all of your requirements. Dave and Troy Audio Doctor NJ |
I would second the Vitus if you can find one used. The best I have ever heard Wilsons sound was with tubes, but the system ran out of gas very quickly due to the low power of the Lamm amp in the system. Low level detail was exceptional on this system. Audiovalve makes some higher powered tube amps that are really good. |
Surprised you'd think you need more headroom over what the Pass 250.8 can deliver. It puts out 250 watts per channel into an 8 ohm load, which doubles to 500 watts per channel into 4 ohms. In stereo, the Luxman m900u by comparison delivers 300Wpc into 4 ohms continuously, although dipping down into 2 ohms the Luxman likely delivers more power than the Pass - but is that really helpful? |