rodman99999
Responses from rodman99999
| Hafler XL600 Vs Hafler 9505 Much difference? Mainly; a greater sense of dynamics, faster/more tuneful low-end, less noise(some call it, "blacker background) and a smoother/more detailed top end(not to say muted, recessed or falsely accentuated in any way). They also allow upgraded fuses and ... | |
| Hafler XL600 Vs Hafler 9505 Much difference? KUDOS! It's a good thing, to learn to do repairs on your own. Enjoy your tunes! | |
| audiphile power cords @mr T: OOPS! It's been a few years, since I did the math(I've slept since then). The old processor has been dropping a few bits and bytes lately, as well. The wire upgrade results are still grand, however. | |
| audiphile power cords Happy Listening! | |
| Top brand speakers Invest in this book and you won't regret it: (http://www.amazon.com/The-Complete-Guide-High-End-Audio/dp/0978649311) | |
| audiphile power cords @Rockdanny- When you have your dedicated lines installed: if using Romex, put a good twist in it, over it's entire length, to reduce noise(EMI/RFI) pickup, and to cancel the wire's own magnetic field. When I did mine; I used a double run of 10 AWG... | |
| Active crossover for 804S and Rythmik subs? Ideally, to keep the system time/phase coherent; the voice coils(acoustic centers) of all the drivers, should be on the same plane(vertically). That would actually require the subwoofers to be aligned with the mains. Many claim that the lowest fre... | |
| Active crossover for 804S and Rythmik subs? Check out the manual(copy/paste the site, referred to previously)). It contains a table allowing you, based on the input impedance of your amp, to select a value for the filter cap(and perhaps resistor). If you can solder: VERY simple. If not: ref... | |
| audiphile power cords @A19- Now you've done it! BTW: If you've not read Michael Crichton's 'State of Fear', do so. | |
| audiphile power cords @W- Perhaps the OP is truly fond of Audis. They are a very well crafted car! I wasn't aware they had built an electric though. | |
| Active crossover for 804S and Rythmik subs? I should have said Grand Reference III. Harry Pearson gave it five stars. Read the paragraph under the heading, 'Variable Low Pass Filter', here: (http://marcs.members.sonic.net/nola/grandref.htm) | |
| Active crossover for 804S and Rythmik subs? Hello Lacee- There is no adjustment available for the Hi-Pass. The goal of the design was transparency and phase coherency, where it's most critical. I really can't imagine why any adjustment, other than the crossover point(determined by the cap a... | |
| upgraded fuse holder The type of spring clip, PCB mount fuse holders you need; seem to be nonexistent in silver or gold plate. It would be nice if the metals of which they are comprised, were better conductors. Unfortunately; metals that conduct well don't have the ab... | |
| How long before your cartridge warms up? @T- Unknown! BUT- pomposity........ | |
| How long before your cartridge warms up? Judy's constructive comment history = 0 |