imhififan
Responses from imhififan
| Preamps with two main-outs kalali,Can you use a ohm meter to check the input of the SP331 when it is power down to confirm that the input is shorted? | |
| Preamps with two main-outs I just did an experiment. Powered everything down and disconnected the ICs going to my Vincent SP331. Turned on the preamp and the MC2200s and they sounded fine. Powered everything down and plugged the ICs back in SP331 without turning it on,... | |
| Marantz TT-15S1 anyone with experience fitting an electronic speed box? If your table run a little faster or slower, a speed controller can correct it, another benefit is you don't need to move the belt/pulley for 33.3 to 45, just push a button like a DD table.a guy from stevehoffman forum use a Project speed box with... | |
| Best / Cheapest desktop micro-amp? MUSICAL FIDELITY - V90-AMP USB $149 free shipping and 60 days satisfaction guarantee from Music direct | |
| Need Adcom GFA-565se info On page 9 of the user manual:All loudspeaker systems having a nominal impedance down to 2 ohms can be connected to, and driven by, the GFA-565SE. The GFA-565SE can drive these low impedances at more than adequate power levels with no difficulty. l... | |
| Can This Amp Power A 50 Foot Speaker Cable Run? I ’m with zavato, the cable should be ok, most important thing to consider is the amp has enough power for such a big theater room without clipping and destroy the speakers! http://myhometheater.homestead.com/splcalculator.html | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- Tim, my guess is a combination of difference of ESR and those old electrolytic caps dried out and out of specs, so a tester that can check the value of the caps and ESR will give us the answer.One thing that surprised me was the cables made such... | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- Btw, all cap in the crossover should be bipolar/non-polarized, therefore the two 2200uf connected back to back. | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- Yes, C1,3 and 4 must use bipolar cap | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- The two 2200uF polarized electrolytic back to back in series to form a non-polarize cap. | |
| Toshiba SP-690 http://audiokarma.org/forums/index.php?threads/vintage-toshiba-ic-boston-system.326512/ | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- I think what Ill do is buy a tester that can check the value of the caps as well as check the ESR and see what pops out at me. Totally agree, and this link is worth a read:http://www.diyaudio.com/forums/multi-way/282847-original-electrolytic-ca... | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- The caps I replaced were: the electrolytic, (2- 6.8uF , 2- 8uF, a 47uf and a 10uF) Also film caps, 3- 3.3uF, 2 -10uF and a 4.7uF.Two polarized electrolytic 2200uF, but these I replaced with electrolytics. C8=4X3.3uF=13.2uF and you replaced it wi... | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- If caps are parallel, measure it in circuit. | |
| HELP AFTER MY MODS, My tweeters are subdued and weak- Just read the caps itself, you can compare the new caps with the existing caps which you took out from the crossover board. |