dover
Responses from dover
| VDH Colibri XPP. Best Load impedance? Well I think your response to Atmasphere above is quite rude.You asked for advice, then proceeded to dismiss it outright.The answer to your question is - there is no best load.It may vary depending on your arm/cartridge combination and phono stage... | |
| Glanz moving magnet cartridges Hi Dgob, Which tonearm were you using with the Glanz G7, was it the Audiocraft ? | |
| kuzma stabi I've got the Stereophile in question.Reviewed by Guy Lemcoe and compared to Well Tempered turntable with Fountainhead base.More transparent, significantly lower noise floor, and better pitch and timing than the WTT. Cartridges used in evaluation w... | |
| VDH Colibri XPP. Best Load impedance? Why did you start this thread if you already know the answer. | |
| Who needs a MM cartridge type when we have MC? I have a MC head amp built by Rito Andreoli under his electronics brand Blue Audio Systems Design, called The Star, it's the best SS step up I've heard, way more transparent than the Klyne 7 I had. | |
| Why does my system sound so shrill and distorted? Hi - the Grado phono stage has 2 settings for gain on the bottom, have you got it on the low gain setting. | |
| Who needs a MM cartridge type when we have MC? Halcro/Nandric - back in the 80's I was sending about 10-15 cartridges per month to Garrots for retipping, both old and new - usually for a microscanner tip, mostly Koetsu's. I suspect that like any cartridge designer they could probably tell what... | |
| find exact center of tonearm bearing If you use a set of dial calipers to measure the diameter of the bearing housing, then measure the spindle to front of housing instead - The pivot to front of bearing housing distance should be :Recommended pivot to spindle distance less ( 0.5 of ... | |
| Who needs a MM cartridge type when we have MC? Garrot Bros -= when I was working with them in the mid 80's they had a modified NAD 3020 running into Brian's home made electrostatics. They had a preference for MMs and yes they loved to put the P77 after a MC for shock value. However they also a... | |
| Who needs a MM cartridge type when we have MC? When I was in Germany a few years ago I looked at purchasing a Kebschull VV150 preamp. Was advised that it used internal MC transformers, located rear left inside. Relevance is not the gain, it is that as you know transformers are not universally ... | |
| Stylus Drag Aoliviero - I can only surmise that the power supply and feedback mechanism of the Raven AC is inadequate if it cannot hold the speed. I certainly wouldn't be happy spending that sort of money on a TT and it not being able to hold the speed accura... | |
| Who needs a MM cartridge type when we have MC? The Kebschull preamp uses internal MC transformers for the MC input, and does not represent a high gain tube phono preamp. You may well have a skewed view of the tube world if this was your reference. | |
| Who needs a MM cartridge type when we have MC? On the contrary, some of us are quite sensitive to high frequency ringing and compression in solid state phono stages. It is quite plausible that tube phono stages are more benign in dealing with high frequency resonances generated by MC's. Certai... | |
| Stylus Drag Tonywinsc,The closed loop open loop is not as simple as implied. They are inextricably linked to the motor technology used, AC or DC.DC motors require a feedback or speed control system to actually run. They will not run without it unless you use ... | |
| Stylus Drag My Final Audio TT has a 19kg platter and very sophisticated motor drive, basically a huge AC motor driven by oscillator preamp and power amplifier which reconstructs sine and cosine waves for the motor and provides precise adjustability for both s... |