bill_k
Responses from bill_k
Absolute top tier DAC for standard res Redbook CD Branislav - you might think it would but it doesn't. That was Dynaudio's top of the line model, and the inverted driver configuration is an integral part of the design. Instead of time aligning the drivers by positioning them in a physically stepp... | |
Digital-input amplifiers NAD offers something close to that in their "Direct Digital Amplifiers". They have several models using this approach - C-390DD, D-7050, and their top model M2. They accept direct digital PCM inputs, and convert the digital signal into PWM which i... | |
Magnepan 3.7i vs Goldenear Triton one Good choice Taters, my taste agrees with yours. | |
Magnepan 3.7i vs Goldenear Triton one I haven't heard them both in the same system, so I wouldn't speculate as to which is 'better'. I would say that these two speaker designs are so different sounding from each other, that after a listen to them even in different systems it should be... | |
Bricasti M1 DAC vs PS Audio Direct Stream DAC Thanks for your response, Sabai. That's very respectable of you to so fairly qualify your DAC comparisons. | |
Bricasti M1 DAC vs PS Audio Direct Stream DAC Sabai - Have you actually heard the Berkeley Reference and compared it to the DS/Yale DAC, or is that just conjecture? TIA | |
A visit to the 2015 California Audio Show Dweller - I don't think so. The LG wires used mu-metal conductors as you stated, while the High Fidelity cables use actual magnets incorporated in the conductive path of the cables. I'm not an expert on magnetics but I think that there are differe... | |
Which cartridge in a Nottingham Analogue? The Nottingham Interspace tonearm has an effective mass of 11.25 grams. That happens to be the same as the Rega RB-250 for those that may have recommendations with that very popular arm. | |
tonearm cable vs regular IC + ground wire A separate ground wire is not always needed. Try it with or without and go with whichever results in less (or hopefully no) hum. | |
tonearm cable vs regular IC + ground wire Not a stupid question at all. You can use any standard RCA interconnect and a separate single wire for ground. The key is to select a well shielded set of RCA interconnects to help prevent any induced hum. | |
Does XLO / Argntum still exist XLO and Argentum were exhibiting at the California Audio Show held this past weekend. See numbers 5 & 93 in their exhibitors list: https://caaudioshow.com/cas6-exhibitors | |
Which cartridge in a Nottingham Analogue? Does your phono stage have enough gain to support low output Moving Coil cartridges? Several on your list fall into this category which require additional gain from the phono input. If it does I'd suggest going with the Ortofon Quintet Blue as a g... | |
Absolute top tier DAC for standard res Redbook CD I haven't heard any of those PMC models, but they use a unique transmission line loading that generally loads the room well but differently than sealed or other vented designs. Should be worth your effort to try them in your room if given the oppo... | |
Any comments on DAC directly to Power amp with no In addition to the factors mentioned above by Czarivey, it often comes down to the quality of the active preamp you're considering. It is therefore recommended that you try it both ways in a given system to determine which way you prefer, as well ... | |
Pani ... New ART-9 up and running ... Fleib - Thanks, that makes perfect sense. |