atmasphere
Responses from atmasphere
| Experiences moving from high-power to lower-power system B&W801 driven by Jadis 500 gave most powerful bass in my room.High efficiency full range speaker driven by 300B gave beautiful human voice.I get the best of both worlds- I run Classic Audio Loudspeakers which go down to 20Hz but are also 98db... | |
| Krell Owners: Is XLR really superior to RCA? Probably not.In my experience balanced properly executed always sounds better, pretty much as you describe.Its not just the connection of course. Balanced operation allows the amplifier to perform better, and also allows the cable to impose less a... | |
| Experiences moving from high-power to lower-power system how would your speakers sound with 800 watts of tube power ? Or it would just be a waist of electricity and tubes ?An output transformer that could manage 800 watts would not be full bandwidth. So, probably not as good. Another issue would be the... | |
| C22 fully balanced? The MP-3 is fully balanced. Not sure if its considered 'entry level'. | |
| Atma-Sphere in CO? @cal3713It sounds like these amps were used- any idea what version they are? The current version is Mk3.3 (older versions can be updated with full warranty reactivation). | |
| SET v. Pushpull So much depends on topology!*Some* pushpull amps have crossover distortion problems but most do not. What push pull amps often do have trouble with is the so-called 'first watt'. Many do have higher distortions in that area, but its usually not cr... | |
| My Amp is Broken - Not Sure What to Do - Any Recommendations? Hm, The output section is right out of OnSemi's application notes. Devices like this give me the willies, since so much relies on them. If it were me, I would be tempted to test the transistor portions to see if they are still good, and if so, per... | |
| Hypex N core module A statement George loves to repeat without practical data to back it up with. The switching frequency is several 100sKHz at the very least and the output filter does not filter it out entirely. Regardless the filter does not have the effect at aud... | |
| Tube and SS pairs If you were to build a system from the ground up, would you get a SS amp to mate with a tube pre amp or a tube amp to mate with a SS preamp? If you have to have some solid state, then I think it better that you get a tube preamp. The issue is tha... | |
| AtmaSphere + Ayre Not if its affected by the volume control. | |
| Best Loudspeakers for Rich Timbre? As an amplifier designer I can tell you that many speaker designers have very little grasp on the relationship that has to exist between the amp and speaker.If the speaker is harder to drive, the amp makes more distortion. In particular if the amp... | |
| Experiences moving from high-power to lower-power system One thing I can tell you is that you don't have to sacrifice anything by getting more efficient and easier to drive speakers! I've yet to hear anything with more resolution and my speakers go down flat to 20Hz. The are 98 db, so I don't need a lot... | |
| Unity Gain Tube Buffer - Choosing the Right Location If you have a buffer that can also convert to balanced, why do you need a TVC? Can't you use the volume control in the buffer? If yes, it will work better if the TVC is omitted. | |
| CDs Vs LPs I have LPs pressed in the early 1950s that play just fine too. One example (Benny Goodman) is 65 years old and still plays fine. The Library of Congress did an archival study in the mid 1980s that suggested that laminated media like CDs would last... | |
| Phono cable advice. The reason you can make an unshielded cable work in a phono situation is that the cartridge is a pretty low impedance. Its hard for radiated noise to impinge the cable when such a low source impedance is present.A further advantage is that unshiel... |