Is there a run-in time for Dynavector XX-2?

I would love to try that cartridge, but my system can't handle such low output without a SUT. Anyway, a quick check states the recommended loading on that cartridge is 30 ohms. As for break in, don't know for sure but I would imagine upwards of 30 hours.

This specific cart dont know. Normally cart change a lot in the first 25-30 hrs and then settle slower. as new they ar normally excessive bright and edgy. Then smooth out and bass will develop.enjoy how it develops.:-)

Not much changes after 25-50 hours but you'll need to fine tune the VTF and VTA.

Very precise alignment is critical.

Hello

My XX2MKII improved greatly after about 50 hours or so, and continued improving for a while after that. Although Dynavector recommends a 30 ohm load, after I achieved optimal set up, and with a Modwright SWP 9.0 Signature phono stage, the cartridge sounds best at 500-1000 ohms. Others on this forum have also stated this loading works for them. From what I experienced, when your cartridge is not optimally set up, it won't sound good at anything much beyond 30 ohms.

Regards,
Dan