Yes. Where’s the bass below 100hz? Check for room modes down there once bass is restored.
Room Acoustics, minimal treatment and measurements
Afternoon all. Thought this might be helpful to some with wondering if room treatments can help with your 2-channel, and how to help visualize and measure what you may not fully grasp hearing wise. I am just using a Mac Laptop and cheapo microphone, and REW, and 6 insulation panels.
This is my Step Fathers system, and pretty much empty LARGE basement listening space. There is a LOT of echo-reverb-ringing that (to my ears) over excites mid to upper frequencies, like being in a busy store/restaurant. With music, this can in ways help make a recording sound like it's in a larger studio/hall/space, but it also mashes a lot together and can over-color the music. This results in lost focus and change in ACTUAL recorded acoustics: so an intimately microphoned musician will sound like an empty room, where an empty room sounds like an empty gymnasium. This, also over-washes a bit of the mid-range and higher bass-losing it's tone and timbre. Major thanks to @erik_squires who has been gracious to help with this process with dead-on advice.
FULL BASEMENT MEASUREMENTS:
34'long x 22'wide x 10'high
LISTENING AREA MEASUREMENTS:
15'long x 22'wide x10'high
Empty room, no treatments and RT60 plot. Listening seat is *in the middle of the whole basement space, under an 18" boxed beam.*
"Treated" room, with RT60 plot. Notice the overall mid-upper frequency taming from 700ms of "ring/decay", to 500ms. Even with this, if you snap your fingers, you still hear a flutter echo. This is from the whole other half of the basement room behind me, mostly.
Crude room response measurement:
Sketch and measurements of where things are in the listening room:
I hope this is helpful and gives you some things to try out that don't cause major disruptions to your system, until you really determine if and where your issues are and then you can buy and mount things. My next step is to see where ON the walls I can place absorbing panels, and how many might be needed for a nominal improvement. My thinking is the bigger issues are the ceiling, front wall, and then 'filling' the space behind the seat just to eat up ambient stray ringing.
- ...
- 30 posts total
@erik_squires See, I told ya! ....you know....I genuinely (and you already know this) thought I was going absolutely crazy, especially the first listen when I got here. He was beaming so proud and my first thought was ".....uh.......so are the woofers on a different amp?.......are you bi-amping? Oh that's probably it, and you forgot to flip that amp on!......." He has the grills on the speakers, so when he's not around I am going to pop it off and check and see. In general though there is VERY LITTLE air coming from the dual ports on the back. He is bi-wiring them from the Rega Illicit, and does not have the straps on the dual posts (usually not needed). Legacy Studio HD Bookshelf Speakers-Tiny Living Room |
@erik_squires I KNOW I KNOW YOU WERE RIGHT!!!!!!!! 😆 I’m gonna sneak down and pop the baffles off when he’s in the shower, and I’ll for sure do another quick room measurement. Do you know is there any harm to an amplifier with bi-wiring AND having the terminal jumpers attached? I know the speaker wires are properly fully connected from amp to speakers (I double checked that first listen)...but I am so curious to determine if it’s possible that the woofers are somehow NOT connected (internally?!). Though at the same time I am preparing myself for things to all be working properly.... ~Alan |
- 30 posts total