I need some help with power in my home!


This is a vulnerable question. I've been doing this hobby for way too long to not know the answer to this. I have seen lots of products marketed for power, but I've never had the need. But here we go...

The power in our house is really unstable. Lights flicker when I turn on the kettle. The space heater nearly takes us down. 

Is there some sort of regulator type thing that stores power and sends it safely and consistently to my stereos? Like a block that sits between the wall and all of my components?

128x128nickrobotron

Hi OP,

I was away and really couldn’t type more than I did. While a voltage regulator/regenerator can help your audio, they can also stress your wiring.

My strong recommendation is to deal with your other issues first. In particular, all your flickering lights are potential signs of arcing which can start fires. In my relatively young (16 years) home I had several such issues which were solved by replacing light switches and outlets. Do everything in your power, especially by hiring a licensed electrician, to solve these issues first.

If your home is significantly older, say 1990’s or older, you may lack an adequate number of circuits. The NEC has evolved a great deal since then and now requires a lot more independent branch circuits than it did back then.

In addition if the outlets were backstabbed, they all need to go, and be replaced by at least Commercial/Residential grade outlets which are back-wired or screw-wired. Especially important if your audio power is daisy chained and several outlets away from your electrical panel.

Even in my "young" home you would simply not believe the number of issues I found replacing switches and outlets. Not to mention, got rid of the ghosts in the lighting.

Overloading a circuit is a bad thing and adding a power regenerator actually may make this more likely. They will draw more current to maintain the correct output voltage.

When you’ve solved your basic house wiring I encourage you to look into a voltage regulator instead of a regenerator for a couple of reasons:

  • Less expensive
  • Less noise

Sadly the modern generation of PS Audio seems to be a lot noisier than the early versions, though also more efficient. I suggest instead Furman conditioners with voltage regulation as better alternatives. However, I insist, do this after cleaning up your electrical otherwise. Doing this in the wrong order may be hazardous.

If you find your house has too few circuits running a new circuit for your stereo is not a bad idea.  It's not always required, like, my little 2 br/2bath home has 20 120V circuits! So I'm not running any appliances in the living room besides the stereo.  If your electrical outlets are shared among say, living room, dining room and hallway you may not be so lucky and a new circuit just for the stereo is a good investment.

You really should call an electrician. I'll bet a nickel it's one of two things: the service ground lost integrity; or... if you have aluminum wiring, the lugs at the panel and breakers need to be deoxidized and re-tightened. 

As @gs5556 sayd:

You really should call an electrician. I'll bet a nickel it's one of two things: the service ground lost integrity; or... if you have aluminum wiring, the lugs at the panel and breakers need to be deoxidized and re-tightened

And a power condition will not ameliorate those issues, if they exist.
We also had a neutral at the service get corroded.
It is literally a “common” occurrence .

You really should fix the route cause of the flickering lights.  A visit from an electrician isn't outrages, and could save your home, as well as fix the issue. 

It could be as simple as loose wiring.  If you're remotely handy and have some basic electrical knowledge, you can kill the main power in your panel, remove the cover, and tighten down all the connections.