Assuming you're in North America, either PartsConnexion or SonicCraft get my vote. Both have a great selection of what you need and have given me great service.
Speaker Cable Rebuild - Need Help
Hi, I have an old pair of Audio Note AN-B (blue color) speaker cables with banana connectors. I need to re-terminate one end with spade connectors to fit my Pass Labs XA30.5 amp.
Where can I buy good quality (gold plated, maybe) spade connectors? Also, I need to get some plastic (pinkish red & black color) heat shrinks for wrapping the cables where the connectors are soldered.
Not sure if you're familiar with the factory Audio Note AN-B speaker cables. At one end, the banana connectors have a special black color heat shrinks (about 2 inches from the connectors)where there's a dent in the middle of the heat shrink. I wonder which end connects to the amplifier? Would it be the end with the special black color heat shrinks? Or, it doesn't really matter.
But I think speaker cables are directional in general.
Thanks for your help.
Richard
Where can I buy good quality (gold plated, maybe) spade connectors? Also, I need to get some plastic (pinkish red & black color) heat shrinks for wrapping the cables where the connectors are soldered.
Not sure if you're familiar with the factory Audio Note AN-B speaker cables. At one end, the banana connectors have a special black color heat shrinks (about 2 inches from the connectors)where there's a dent in the middle of the heat shrink. I wonder which end connects to the amplifier? Would it be the end with the special black color heat shrinks? Or, it doesn't really matter.
But I think speaker cables are directional in general.
Thanks for your help.
Richard
8 responses Add your response
Furez spades and bananas are very good and come in copper or silver plated copper From what I have read it appears you don't have to worry too much about tarnishing on silver plated connectors because that brown-black tarnish (which is actually silver sulphide) is a surface issue and is very thin and therefore presents little resistance (if any) Whereas tarnished copper actually pits the surface. It also takes considerable atmospheric moisture to form and most often, simply reseating the connector is normally enough to break through the tarnish to restore good contact. Also, with most connectors you will probably not have any tarnishing where the two surfaces actually make contact. I would recommend replacing all connectors for best results I use them and was amazed at the difference they made Just google Furez for retailers Regards |
I don't know if you want to go that route, but Cardas makes some nice adaptors. http://dedicatedaudio.com/inc/sdetail/2246/34729 |