Please Help T3F problems


I really Miss my Goldmund Studio/T3F

As soon as I turn the table on the toneearm drives straight to the spindle risking my Kouetsu Onyx cartridge. It did this to me years ago and I found that by repeatedly turning it off and on I eventually got it to work and I just left it turned on. That worked for awhile but now it will not come out of that mode.

I have a Krell, Apogee Fullrange, Suprateck system and cds just aren't cutting it.

If anyone has any experience with this, Id really appreciate any assistance 

 

 

Thanks in advance for any help

Les

scotchboy

@scotchboy 

Actually you should not add mass to the Ittok headshell if you run the Koetsu Onyx on the Ittok.

I had a customer with Linn/Sumiko MDC800/Koetsu Onyx Gold - sounded superb.

The MDC800 is only 11g effective mass.

The Ittok LVII is 13.5g effective mass.

The Onyx is quite heavy at 12.5g, ( most of the Linn cartridges are around 7g ) and adding further mass to the Ittok headshell with the Onyx installed will degrade the sound. If anything you might need a heavier counterweight to optimise the sound by running the counterweight closer to the pivot.

So - if you want to run the Ittok/Onyx - just install as is.

Be careful, the Onyx bodies are easily cracked - do not do the bolts up too tight - just a gentle pinch.

 

 

Thanks Dover

Especially on installing the cartridge. The Linn rep once told me "there are three kinds of tight: theres tight, theres F_ _ _en tight and then there's Linn tight" 

Lol, the next cartridge I installed was a Grace cartridge and I crushed the body

@scotchboy 

Yeah Ivor was pretty funny. The Ittoks have "soft bearings" and they recommended taking the arm off to install a cartridge so the bearings don't get damaged. Now I know why. Actually the Ittok is underrated - it does work with a wide variety of cartridges, assuming it is in good condition.

Good point on the already heavy weight of a stone body Koetsu. I neglected to take that into account.