Need advice! Do I upgrade DAC or buy a new player?
The CD player is an Emotiva ERC-3, I like the player but want a better soundstage a bit deeper and dare I say more analog sounding. I am a huge soundstage freak so if a sacrifice were to be made it would not be there. I am running balanced out of the Emotiva. I don't need SACD but ok if it's there. I don't have a problem with pre-owned I don't need a DAC that downloads FLAC or can be hooked up to any other sources other than the Emotiva being used as a transport. As for budget I would say $1,500 to $2,000 if it makes sense. Any advice would help thanks!
This is a very old thread, but since there are a few new posts, here's my recommendation buy a
Oppo 105 (which has built in VVC)
You can buy used 105s ~ $900. then upgrade
Im not a DIYer by nature, but the Asian company I purchased the following from has easy to follow photos on installing the upgrades Go to eBay and select whichever Linear Power Module you can afford, also get the 110/220 jumper and replace your IEC with one that has a superior IEC (mine has Furutech with a silver jumper that connects to the LPM. It's so good that I no longer use a preamp hth |
For a CD player look into the Sparkler Audio s503 ($1600) I have one and the NOS Dac sounds fantastic! I use it now as a transport and it rivals some of the best I’ve had! Been around this hobby for a loooong time and have had a lot of gear but this is a very good player. Be safe, Chris http://charneyaudio.com/sparkler.html |
I too, am facing this exact dilemma. I am a born again VinylHead yet I have CDs 💿 that will never be converted to vinyl. I adore my Acurus ACD11 which matches my Acurus A150 AMP & Acurus RL11 PREAMP however, it’s the Acurus ACD11’s 1997 1 Bit Burr Brown DAC that I found wanting. So I did the next best thing—-I slapped in an SMSL Sanskirt Anno 6 with its dedicated SMSL Linear P/S and it sounded Fantastic (Wolfson WD 8740 DAC was SOTA in 2014). So should I run out and buy the new SMSL Sanskirt 10 anno, the Topper D30, the Chord or fill in yer blank here? Not necessarily!!! Since Im using the Acurus ACD11 as a transport, the best I can achieve on its Digital Output is 24 bit/192KB—-which is what I have now. That means it’s pointless to do DSD 512 or upwards else 64/720KB PCM because, if I’m using the outboard DAC for the ACD11—I am throttled down to 24bit/192KB. Would a better (newer) DAC chip make my CDs sound better than I already have with the Wolfson WD 8740? I’m not inclined to think so. CDs are an obsolete, 40 year old musical delivery system which most people do not buy new—-I stream mine on Apple iTunes/IMusic. My ACD11 Grandpa Box gives me sufficient audio pleasure (Because with COVID-19 you can’t get the oral kind anymore) when I’m too feeling rushed to do 180g LPs. if I get a dedicated music streamer, yes, I will get into DSD 512++ but I can’t see my upgrading the SMSL to a better outboard DAC. |
Well, yeah .... you got AR on the front end followed by Bryston, and an entry level CD Player. Dude, your world is going to change. With $1500-2k, you have a host of high quality options that will allow the AR, Bryston, etc really sound their best. So far, the Emotiva has been the limiting factor for your Sound Quality. If the EMotiva is used as a transport, it will still be your limiting factor, b/c you will be feeding a lower sound quality signal to an expensive DAC. To be honest R, I would replace the Emotiva altogether with a stand-alone CDPlayer that at the least has a digital SPDIF RCA out (will give you future options for other DACs). There are many great CD Players out there for under $2000. |
Post removed |
Frankly, I would not waste any real money on a Transport, only on a CD player that you use the analog outs for DSD. I do think you should improve the transport jitter though, by adding a reclocker to the digital cable as well as a better digital cable. The soundstage/imaging problems you are describing are likely jitter related. To get the jitter levels you can get from a $599 Synchro-Mesh reclocker and a $499 Reference BNC cable (20psec), you would need to spend at least $20K on a new Transport IME. You can make the reclocker even better by upgrading the power supply. I would do this first before you consider a new DAC. 30-day money-back, less shipping. As for the DAC, I can highly recommend changing to a DAC with balanced outputs if you don’t have that already. This will usually give you a lower noise floor and better soundstage as well. First, just try the new cable and reclocker and see if this does not satisfy you. It also provides galvanic isolation, eliminating a ground-loop that you have now. BTW, if you also have a home theater with SS processor, I can highly recommend the iFi SPDIF Purifier for $149 driving my Standard BNC S/PDIF cable to reduce jitter for Dolby Digital and DTS. Steve N. Empirical Audio |
I've been out of the CD game for years, so I really have no skin in the game when it comes to CD players..or whether you should upgrade it. I will say, if you upgrade the DAC, if you opt to venture out towards other sources, you'll be able to use the DAC in those situations. Where as, just upgrading the CD player, that's all it would be leveraged for. Maybe that's what you want, but really nice DAC's can be had in your budget. I have 2 DACs, the Ayre QB9 and the PS Audio Direct Stream Junior. The DSJ, I believe I've seen them used for around $2500ish, a little bit out of your price range. The upside with that DAC, not only does it put to shame some DACs that cost 2x as much, they're constantly fiddling/upgrading their code; which can be upgraded to or you're able to switch back to earlier versions. The Ayre QB9, I pick up for $1200 and it sounds incredible. Going a little above and beyond what your original request was: I sold off my entire vinyl collection about a year ago. I found myself reverting to hi res files for listening vs. listening to vinyl. If you ever want to step forward with your vinyl preamp, PS Audio's Nuwave phono preamp sounds majestic. It sounds even better when you connect it to the DSJ over I2S. I had always ran Moon phono preamps, the PS Audio setup was unbelievable sounding. It was like when you first heard a CD vs. tape. Happy hunting! |
I think an Electocompaniet ECD-1 would be to your liking. Basic dac like you wanted,it upsamples everything to 24/192. Use the aes/ebu digital output from your Emotiva with a Kimber Orchid cable into the dac nets a very analog sound. Also has balanced outs into your preamp. Read the great reviews on this unit. One currently for sale here. I also am selling one on USA Audiomart that has been modded by Steve Nugent of Empirical Audio fame. His mods take the already excellent stock unit to a whole new level. Cheers, Den |