as i understand it the number of times you can split a signal without degradation depends on the output/input impedances of the amp/preamp. in your case i would just use a speaker selector, which you can get very cheaply.
How Many Times Can You Split A Subwoofer Signal Using A "Y" Connector?
My Marantz AV7705 preamp processor has two line level rca subwoofer pre-outs.
I am trying to emulate the Audio Kinesis SWARM subwoofer system.
Can I connect four or eight powered subwoofers to the system using y-connectors?
Can you split a single subwoofer signal into two or four signals?
These are the subwoofers I'm considering using...I'd like to use eight subs if the signal doesn't degrade from having it split so many times.
Each sub has a 12 inch driver with a 115 watt internal amp (230 watt peak)
Klipsch R-120SWi wireless subwoofer...
I will hard-wire the subs, I will not go wireless
SPECIFICATIONS: FREQUENCY RESPONSE 29Hz - 120Hz
MAXIMUM ACOUSTIC OUTPUT 115 dB
AMPLIFIER All Digital AMPLIFIER POWER (CONT/PEAK) 115W RMS/230W
Low-pass, 0/180 phase, Auto Power On
12” high excursion spun-copper IMG woofer MDF Bass-Reflex via rear-firing port
Line level/LFE RCA jacks 16.5” (419 mm) 14” (356 mm) 19.2” ( 488mm) 31 lbs
1 response Add your response