wsrrsw,
Wow that is surprising. There is a difference with the transceiver used. But it shouldn't have swayed you to prefer the Ethernet cable.
ozzy
- ...
- 50 posts total
Ozzy, Not definitive in this matter but when I had an EtherREGEN, after dark PSU and clock I preferred the copper as did another member I corresponded with on the forum. Go figure. The Clarisys Minuet’s are a feast for the eyes and I bet with the Michi’s and with the quad subs you can blow the roof off.
|
“I preferred the copper” That’s been my experience as well. I have taken the approach to clean LAN grunge and block noise by adapting to Telegartner Opt Bridge 1000M - Optical Isolator. This gives me best of both worlds and I am extremely pleased with the results. I am using a pair of FTA Métis LAN cables in and out of Opt Bridge…I’m done tweaking my Streaming setup (for now). |
| Post removed |
Hard to believe. I thought it was a very large improvement using the Fiber over Ethernet cable. At least with my Lumin, which accept fiber direct without needing a conversion adapter. I did however purchase some very good Transceivers. And I am going straight from my Lumin X1 to my amps. (No preamp). ozzy |
- 50 posts total