Electrical question re dedicated line


In my home situation(new house) the electrician who came by to install a dedicated line said it would be too difficult and very expensive. Another electrician said that I could have a dedicated line but it would be external and would travel accross the outside of my walls(insulated of course) and would have a little box for the receptacle outside of the wall on the wall. My question is that the fact that my system is on a circuit with it's own breaker, is that kind of like a dedicated line? The breaker my system is on has 4 seperate receptacles on it in my room but only my power regenerator(PS P500) is conected to one of those receptacles.In other words, all that is on the circuit that goes to the 4 receptacles in my listening room is my P500. The other receptacles are not in use. Is that kind of like a dedicated line? Would there be much advantage to doing what one electrician said was possible and have an externaly run dedicated line?
My system is :
Pass X250 amp
Pass X1 preamp
Talk Electronics Thunder3.1b CDP
Hales Transcenence 5's speakers
PS Audio P500 power plant
Shunyata Aries and Lyra interconnects and speaker cable
Prototype power cords which were not given a name but are good as I've compared them against Shunyata King Cobra V2 and Synergistic Designers Reference and much prefered the cords I have.
Any help would be valued. Thanks
mitchb

Showing 2 responses by peterd

Alraul,Oh sorry I did make a mistake in my description.
Both grounds are connected as like a grid, but the new rod is the closest ground to my gear and a ground wire leads from it to the main house ground.
That way the grounds don't interact or cause one to be the primary ground and sacrificing the other.
Peter
Mitch.I think that it involves running a main line upstream of your breaker panel.I didn't do this but changed the breakers and lines to the uppermost location and cleaned and pro-gold the tabs on the breaker.Don't know if it did much.May be a little.
What did make a difference was driving in a separate ground rod and then from the PS Audio power port plug I ran a separate ground wire from the dedicated ground lug on the plug to the new ground rod.
Result ......no noise ! I always thought that a dedicated outlet and all and a PS Audio 300 would have cleaned things up but with that isolated ground I often look at the equipment between tracks to make it is on cause it is
so quiet.
Hope this helps.
Peter