2. amps-preamps
  3. 1343680892

Audio Research REF II failed

I guess I should have changed the power supply tubes earlier... stupid me... Power amp shuts down when ever I take the pre out of mute. There is a component next to the second 6h30 (the bottom one to the right) that smoked. I assume that is a screen resistor? At the dealer now to get repaired and retubed. Booo!
no_money
10 responses Add your response
marakanetz's avatar
marakanetz
5,473 posts
 
not a big deal of an amp to work on DIY. watch some tubes and do it.
no_money OP
638 posts
 
Yea, I could do it myself... just worried about the resale value. Some folks get put off if it isn't done at an authorized dealer so I took it in.

At least I didn't drag the 90 pound amp down there LOL!

I would have really been mad at myself then.
marakanetz's avatar
marakanetz
5,473 posts
 
I guess I'm missing something: Is it like accident on the car title? Who knows and who cares?
no_money OP
638 posts
 
I think full disclosure on selling a component is the right thing to do.
marakanetz's avatar
marakanetz
5,473 posts
 
did lots of work myself on my VTL I used to own and sold with no problems.
hifigeek1
770 posts
 
Sounds like DC is coming out of your preamp.....
no_money OP
638 posts
 
Yea, 2 resistors blown. Having the tube socket replaced as well.

Repair isn't much really. Retubing cost much more.
marakanetz's avatar
marakanetz
5,473 posts
 
blown tube socket in ref II?? wierd. aren't they're using ceramic ones??
gundam91
506 posts
 
Not 100% sure, but I remember hearing from some owner something about a resistor was put in place to protect the electronics when the power tube goes out. So this may be normal. Best thing is to call ARC to verify.

FrankC
no_money OP
638 posts
 
Tube socket is likely ok, just replacing to err on the safe side while they are in there.
Log in to respond
More to discover
80x80
Pass Labs XP-22
80x80
KR Audio P135 MC Pre Amplifier w/MC Phono
80x80
BAT VK80t