A not sarcastic question for the power conditioner/upgraded power cord folks
And I realize that there are those that don’t believe in either
Assuming you use a power conditioner and after market power cords, do you feel that the power cord from the power conditioner to the wall might be a limiting or even a negating factor to the performance of the after market power cords that run from the power conditioner to the gear?
The reason I ask is that I was about to embark upon some more experimentation with different power cords and where I plugged them into when I discovered that the aftermarket cords I had purchased before and some recent arrivals are actually a meter shorter than the ones that came with the gear. This doesn’t matter for the amp due to its location, but when I did my last power cord upgrade I ran my CDP and pre into a conditioner so the length for those didn’t matter either, but as I was doing the musical chairs with power cords thing today, I also was intending to run the CDP and pre straight into the wall on separate dedicated circuits, but I found out that I am a tad short on those two.
Which doesn’t preclude me from moving my dedicated circuit outlets up a couple of feet, and I suppose I probably will, but I was curious as to the opinions about the limitations of a power conditioners power cord.
- ...
- 121 posts total
| Post removed |
my eyesight is getting pretty bad, but for this sentence:
I can only count three no matter how close I get my face to my screen. Meaning that the period at the end of the sentence (the second sentence which also utilized an ellipsis) was omitted. Which doesn’t matter to me, but considering that it was a critique of my ability to communicate, I just thought that I would bring it to the attention of " @chrisoshea ." The same "chrisoshea" who I am now pretty sure is someone else’s sock puppet. Regardless of any of that: my system is down for maintenance. I am going to run my 2 m power cords directly into the wall from the gear.
|
- 121 posts total