schipo
Responses from schipo
| Long Cables w/Short Speaker Cable or Vice Versa? All things being equal, it is MUCH better to have your high-level signal (Speaker wires) runs longer than your low level signal (Interconnect). It is not an opinion, it is simple physics. | |
| Long Cables w/Short Speaker Cable or Vice Versa? shortest possible interconnects, just because they send lower level signals which can be more prone to interference and such.Depending on the speaker load if its an easy one to drive then most times longer cable is best. | |
| Long Cables w/Short Speaker Cable or Vice Versa? (B) Short Interconnects with a Long Speaker Cable run? I would consider this option. | |
| CD player vibration from CD's leatherneck why not do what i do with warped CDs. I put it under enormous amounts of heat and pressure. These conditions will form diamonds naturally. | |
| Turntable leveling... Wtt founder and designer of the welltempered tables said. Level the table but don't be fanatical about it. | |
| Front port vs Rear port Yes front ported will allow you to place them closer to the wall. But don't let that be the deciding vote when making a choice. You can chose a speaker that is rear ported and keep it close to the wall for casual listening. And bring it out when y... | |
| Tubed preamp with Krell KSA 150 amp? I would go for a CJ tube pre. There very lush and warm compared to AR... | |
| Well Tempered Turntable Specifications May I ask why you really need those specs? The tables are great at retrival and can't see you going wrong with either model. I would ad, if your going for the reference? Then look for the Amadeus. | |
| Is age bad for solid state amps? yes yes and yes..caps go bad transitors die a slow death and all other parts including boards have there own life cycle.Just like us. | |
| JADIS ORCHESTRA if you don't know and most likely if dislodged it might need to be resoldered back into place. I would to be safe take it to a tech WHO KNOWS TUBE GEAR and has worked on them. Thats a fine piece of gear why not be safe then sorry.As far has the di... | |
| Hafler DH-200 Toasting speakers sounds like your speakers are consuming a large amount of DC current and this might have caused the damage. High ac voltage on a speaker is better than a low dc voltage.Thiels need a more powerful amp then a Hafler 200. You were most likely clippi... | |
| Is my room OK for Magneplanar 3.6's Laurence:I only said you were pushing the room size because I am writing with some experience using maggies. I purchaed my first pair in 1986 the MG III from a very famous audio salon in NYC. When delivered the tech took one look at the room for s... | |
| Loss of My Treasured System...stolen at Customs I am sorry to hear this and again you have support here on the Gon...best to you.. | |
| Is my room OK for Magneplanar 3.6's your pushing it with the size of that room .Maggies need to breathe.Your room might work but again pushing..good luck | |
| Speaker Cable Requirements 1 Ohm Load A long run of cable use a heavy 10 AWG wire..to be safe. With shorter runs at 2ohm load I would say you could go with a 12AWG or even a 14 and be safe...my opinion only and sure many will think different. |