sbrownnw
Responses from sbrownnw
| Has anyone tried a "leather" turntable mat? Found this shootout link:matsLooks like the leather mat "won" for best overall out of the 6, including best bang for the buck. :) | |
| Has anyone tried a "leather" turntable mat? I got one of these on my RP6:leather matI think it sounds and looks great. My local Rega dealer said I should put it side-by-side to a $65 Herbie Mat . I've used Herbie Mats on other tables and they were good, but I like the fact that the leather ... | |
| turntable light These look promising:Ottlite wing shade lampOttlite craft light - dimmableOttlite clip lamp | |
| turntable light black clip light | |
| turntable light I use this one:black clip lightIt is cheap and small (wish it was even smaller). Plus, I usually don't like LED light colors and they can be expensive. | |
| When do you choose vinyl over digital? Maybe a basselope ;) | |
| Best way to warm up the sound Buy the Cardas freq sweep and burn-in record. Has a speed strobe check lable and is a good test / burn-in record. | |
| Best way to warm up the sound Did you check your TT speed? How close is it to 33.3? | |
| Wildly fluttering woofer Did you move the table recently? If not, probably something in the cartridge or phono stage (tubes?). | |
| Best way to warm up the sound Check your turntable speed. My pro-ject Xpression III ran quite fast. Something I didn't realize until I replaced the table. Both pro-ject and music hall are from the same manufacturer. I also had a speed box. LPs can sound bright when running fast. | |
| Dubbing FM onto tape.... Don't touch that dial, there's KOME on it ;) | |
| Custom Plinth for an older Sota Sapphire How about a metal-like laminate?http://www.chemetal.com/ | |
| Rega RP3 Bias/Anti-Skate I'm using zero antiskate on my RP6 after adjusting it on the fly. That eliminated all inner groove distortion I was getting on some records. | |
| denon 103/wood, benz glider, AT ptg33, or AK audio Cannot wait to pull the trigger on a AT33 ptgII for my rega RP6. Just had an ortofon put on it when I got the table, so going to put some hours on that. Also hope to do the GT ref sub platter very soon. | |
| Phono Hum w/ Pro-Ject Debut III What interconnects? Did you try some shielded ones? |