sbrownnw
Responses from sbrownnw
| turntable light I use this one:black clip lightIt is cheap and small (wish it was even smaller). Plus, I usually don't like LED light colors and they can be expensive. | |
| When do you choose vinyl over digital? Maybe a basselope ;) | |
| Best way to warm up the sound Buy the Cardas freq sweep and burn-in record. Has a speed strobe check lable and is a good test / burn-in record. | |
| Best way to warm up the sound Did you check your TT speed? How close is it to 33.3? | |
| Wildly fluttering woofer Did you move the table recently? If not, probably something in the cartridge or phono stage (tubes?). | |
| Best way to warm up the sound Check your turntable speed. My pro-ject Xpression III ran quite fast. Something I didn't realize until I replaced the table. Both pro-ject and music hall are from the same manufacturer. I also had a speed box. LPs can sound bright when running fast. | |
| Dubbing FM onto tape.... Don't touch that dial, there's KOME on it ;) | |
| Custom Plinth for an older Sota Sapphire How about a metal-like laminate?http://www.chemetal.com/ | |
| Rega RP3 Bias/Anti-Skate I'm using zero antiskate on my RP6 after adjusting it on the fly. That eliminated all inner groove distortion I was getting on some records. | |
| denon 103/wood, benz glider, AT ptg33, or AK audio Cannot wait to pull the trigger on a AT33 ptgII for my rega RP6. Just had an ortofon put on it when I got the table, so going to put some hours on that. Also hope to do the GT ref sub platter very soon. | |
| Phono Hum w/ Pro-Ject Debut III What interconnects? Did you try some shielded ones? | |
| warm sounding cartridge for rega arm Looking forward to trying an AT AV33PTGII on my RP6, which has been described as a great tracker with its fine line stylus and just a touch on the dark side of neutral. | |
| HELP-woofer moves alot when playing lps My Pro-ject Xpression III did this same woofer pumping issue. It was very noticeable as soon as the stylus hit the record before the music started. Same system, same table location, same cartridge, same phono pre, same high efficiency speakers (92... | |
| help with RP6 setup @Bacobits1, is the Vista Audio Phono-1 mkII both MM and MC? I am surprised the gain is only adjustable on MM. How hard is it to add / remove resistors to adjust input impedance? How much A/B comparison did you do with the Vista mkII vs the Jasmine... | |
| New cart for under 1K I hope to try the Audio-Technica AT33PTG/II from 2juki on ebay for my next cart. You can get one for below $500 and has some nice remarks about it (all the rave in Japan, etc. and tends to run just a bit dark).Not associated with 2juki at all. Jus... |