rwwear
Responses from rwwear
Anyone still excited about HDCD ? I know that Krell has stopped adding it to their processors because of the higher cost. | |
can someone compare krell kas to the new fpb's I was told by a friend that works for Krell that the FPB's are better. | |
I just sold my cd player what should i get? A record player. | |
Rotel RMB 1095 - no 12 volt trigger Niles Audio makes a power sensing switch that turns on an outlet when something plugged into it is turned on. You can get it with a video sensing input or power sensing. | |
Denon DVD2900 Vs Marantz Dv8400. It makes one wonder how close these two players are to each other since Marantz now owns Denon or at least they are both owned by the same company, D&M Holdings. | |
Has anyone used the Spin Clean Record Washer System Yes, someone has. | |
Video Hum Bars The reason this happens is that you have too many paths to ground usually. It doesn't always cause problems but it sometimes does. In most cases, and I've seen many, breaking the ground on the TV cable input fixes the problem with no side effects. | |
Video Hum Bars You need a ground break where the coax attaches to your TV. You can get them a Rat Shack for a few dollars. | |
DVD Picture Problem -- Please Help Most modern TV's have a tilt control in their setup menus. It will usually fix the problem. Some DVD players have this adjustment also. | |
Power conditioner for Krell Mono Block? I have a dedicated 30 amp line for my 600c and do not use a line conditioner but Panamax's new high end models offer balanced and isolated outlets and have two recepicles without current limiting. | |
Longbox CD's The quality is probably worse. | |
XLR wiring question? The cables are wired the same. It's the equipment that's different. They reverse the positive and negative. So, even if the wire was reversed it wouldn't matter because it would be reversed on both ends. | |
Krell KAV250a or Krell KSA 100s Go with the 100S | |
Thoughts on a Marantz MM9000 amp for a 4 Ohm ... No, the amp itself would be the one at risk. But, most amps can drive a 4ohm load easily and it should supply more power into the lower impedence. Look on the back of the amp next to the binding posts and see if it says anything about speaker impe... | |
Help Any Krell KRC Owners I am only going on what I was told by my friend at Krell. He claims that the HR has better resolution. It would be worth it to me if I had the money. If not, the KRC is still a fine preamp that has all of the features of the HR. |