rodman99999

Responses from rodman99999

15 ohm speakers yea or nay?
     What impedance tap choices do your tube amps have?      Bearing in mind some are internal: which are you using?      I hate to type, thus: see if any of this helps- https://www.dhtrob.com/overige/tubefriendly_lsp_en.php    
Does dose anyone see these speakers in real?
     Fairly certain: I'll never be faced with the problem.                                     ¯\_(ツ)_/¯  
Mods for HK Citation 22
     Should the OP not respond: consider that his question is almost four years old and he hasn't been on this site for around two.                                        Just sayin'.                                    Happy listening!  
High output MC cartridges for phono with 40dB gain
@crazybookman -        The SUT suggested above should be a very good match for your DL-103, as it has selectable loading between 50 and 100 Ohms, the recommended load for the Denon being 100 Ohms.         The only caveat: any hum/noise present w... 
Do older power cables still hold up to newer ones?
@fthompson251 -  This amp is not going anywhere-(except for the update at VAC in FL)                                               +1       Good decision and any upgrades to the power supply (if in their options) will make power cable changes... 
Do older power cables still hold up to newer ones?
 I enjoy the humor  @jasonbourne52 brings to the table.                       Big fan of Greek Tragicomedy, too?  
Is this a audioquest cable counterfeit fake?
@bishop55 -      I would think: contacting the cable’s maker would be the best course, for the most decisive answer.                  https://www.audioquest.com/contact-map      An Audioquest resource, for verifying cable authenticity, on this ... 
The Economy.. will hi end audio mfgs lower prices?
@cd318 - "And this time the government isn't even bothering to hide the fact that they're in on it too. Sorry Mr Schwab, we've all seen your plan, and no thanks."                                                       WHAT?       You mean: yo... 
The Economy.. will hi end audio mfgs lower prices?
     AND: they just THOUGHT things were bad back then!  
Schiit's solid-state 6SN7
             They offer a fifteen day, money-back, trial period.      At least it would be a low-risk experiment*, for the, "curious".                                *No poxes, just postage  
Schiit's solid-state 6SN7
     That had to be one of the funniest, Seinfeld run-on, jokes ever aired.  
Well I joined the Silversmith FIDELIUM Speaker cable club today
It's a shame that so many of these threads devolve rather than serving as a resource based on real world experience for those seeking to learn about products they may wish to audition.                                                            ... 
Dedicated AC Circuits: It's not the noise, it's the upstream problems
@ozzy - While you’re at it, also check the connections in the breaker box. I was surprised that a couple of mine were not fully tightened down. ozzy      Some folks neglect to come back in a little while to retighten connections, after a new ... 
Best Type of Interconnect for Turntable?
    Make that, "TOO many variables..."     Need to proofread/proof-read/proof read, now and then!  
Best Type of Interconnect for Turntable?
     What you pick for a phono cable (for the best sound), should be determined by the type of cartridge chosen (MC/MM/MI) and that cart's specific loading requirements*.      To many variables for any specific advice, until you narrow the field ...