rodman99999
Responses from rodman99999
Triangle Cellius SE Modifications? I'll be here! Happy listening. | |
Triangle Cellius SE Modifications? Based on the fact that you added a supertweeter, I feel it's safe to assume that you aren't into the, "warm" or "laid-back" sound that some embrace. I can thus recommend either V-cap Teflon/tin or copper foil caps, which are both very liquid and r... | |
Triangle Cellius SE Modifications? Hello Brad- re: My other thread- Thanks for your confidence. Not having ever had my hands, or ears, on a pair of your speakers; I can't make any specific recommendations. Have you taken a look inside the cabinet and determined of what quality the ... | |
"Violinists blast holes in violin experiment" I particularly liked the title of the article, 'They Blinded Me With Science'(very profound, but- could have been, "Deafened Me"). The bottom line though: As long as YOU are satisfied with the staus quo(your system, listening abilities or whatever... | |
FYI Anyone can use your Pay Pal account Now that you have so fully outlined how one can perpetrate this crime; I hope no one that I have purchased from(via Paypal), on this site, is a crook. | |
Do you believe in Magic? "When it comes to this hobby, I have always found more value in giving the observer of a particular unexplainable effect the benefit of the doubt, than in assuming that because there is no "scientific" explanation it must be a figment of his imagi... | |
Psvane Teflon capacitors real or fakes? Mr T- Point taken! Happy listening! | |
Psvane Teflon capacitors real or fakes? If your dielectric is heating up AT ALL; it's because you are not using a heatsink, or not using one properly. Something as simple as an alligator clip, attached to the lead between the component being installed, and the point being soldered, will... | |
Do I need a phono pre amp? Phono stages/preamps RIAA equalize the signal of your cartridge. If you did use another, going into the phono in of your preamp; your signal would be equalized twice and the results would not sound very good. | |
tact reliability Have you tried to contact Boz by phone? It might cost a bit, but- it IS a way to avoid, "failures to communicate." | |
Snell EIV: refoam or replace? I've purchased parts from Bill, numerous times: (http://www.millersound.net/service.htm) He's a very knowledgeable, honest businessman, and I recommend him highly. | |
220v/50hz to 120/60hz There is contact info, at the bottom of the Rega parts list, for advice:(http://lpturntables.blogspot.com/2011/09/list-of-upgrade-accessories.html) re: pulley removal- Try a wheel puller for RC cars, from your local hobby shop. | |
Magnepan fuse voltage They come with 250V fuses. | |
copper slug If all you intend to do, is eliminate a fuse: solder a large gauge piece of wire across the fuse holder's terminals. Replacing a fuse, with a piece of copper, just provides two more contact points, for corrosion to form. | |
schematically speaking There are numerous sites, such as these: (http://www.stereomanuals.com/) (http://www.audio-circuit.dk/Schematics.htm), that offer schematics and service manuals online. Yes- Caps can always be replaced with like values, but different sources. One ... |