pbnaudio
Responses from pbnaudio
| PHONO STAGE FOR REGA RP1 or RP3 Spend a little more and get a real one, the Liberty Audio B2B-1 :-)From its maker ThanksPeterliberty | |
| Any good Audio Stores in San Diego Well you can always schedule a visit to our showroom ThanksPeter | |
| Ortofon 309 arm: original vs made in Japan? While I do not have the "original" one I do have the one thats made for Ortofon by Jelco and it is a very fine tonearm - made in Japan - normally means very well made and this one is no exception.ThanksPeter | |
| Fuse : Voltage ratings No issue with using a fuse with a higher voltage rating - as long as the current rating is the same.Peter | |
| Witch vinyl LP , EP or single you acquired FIRST? Beatles - Rubber Soul Peter | |
| Locating capacitors Mouser capacitorHeres one that should workHappy Soldering :-)Peter | |
| Goldfinger Statement, Lyra Atlas or Ortofon Anna? The Ortofon Anna is not shipping yet - I have mine on order :-) Have had the A90, the Clear Audio Insider ref wood and the XV1S too, as already stated all are great cartridges.Of all of them I tend to prefer the Ortofon's the best they are for lac... | |
| Phono Pre amp for a Krell system LibertyThe nice folks at Stereophile put it on their website today | |
| Phono Pre amp for a Krell system Liberty B2B-1 - Read JA's follow up in this months Stereophile and MF's Glowing review in Last Octobers issue.And yes I make them :-)Peter | |
| Locating capacitors You can most likely use any electrolytic capacitor of equal or higher voltage rating - Mouser have several make sure it fits size wise and of course make sure you get the right value (uF) - also it would not hurt to use a 105'C cap they hold up lo... | |
| Next Cartridge Have had several top flight Ortofons - Have you considered the A90 ? still available NOS here, or depending on budget the new Anna ? | |
| Phono preamp for Ortofon MC30 super You should consider the Liberty Audio B2B-1 - I make them - read MF's review in the October last year issue of Stereophile and John Atkinson's follow up this current issue.ThanksPeter | |
| Why do I like Class AB better than Class A? Elizabeth,Your PURE Class A Forte 4A was biased at 800 mA per node - resulting in an astonishing 9 watts in Pure class A into a 8 ohm load - the rest of it in A/B - and yes it ran hot, but it sounded pretty good. I have had several of them through... | |
| Why do I like Class AB better than Class A? Correction, "although depending on rail voltage it would have a maximum" should be "could have" | |
| Why do I like Class AB better than Class A? Doogie - there is no difference in maximum power output in "Class A" or A/B its just a matter of how much bias current there is running in the output stage at idle The term "pure Class A" is a bit of a misnomer too as a speaker load is far form fl... |