markpao
Responses from markpao
| Why not horns? Proud owner of Klipschorns since 1988 and wouldn't consider any other speaker at this time. No "honky" sounds as described by some others here. My wife keeps bugging me to rip out the carpeting and put in wood floors- now this could be a problem f... | |
| To buy or not to buy a used cartridge? Having purchased 9 used cartridges here on Agon (and 1 on ebay), I can attest that it is no more risky than other used component purchases. Feedback check is essential here. I have received one cartridge that was not as described (and no, it wasn'... | |
| Help with a Hickok TV-7D/U setting line voltage There are plenty of operating manuals with test data available for this tester online. Try ebay. | |
| Hickok TV-7/U owners Makes sense, thanks a lot. I am fairly new to tube testers. I noticed you have 0 for the shunt setting. Is that the number specified or is that where it should be set when there is no number specified? I see there are a lot of tubes in my manual w... | |
| Torn between two amps Enough said. Bad idea. I think I was enjoying some Knob Creek when I posted this. I'll probably just hang onto both amps and rotate them from time to time. I've been listening to mostly vinyl for the last 12-18 months anyway. Thanks guy's for your... | |
| VPI SDS question I use the SDS with my Aries 1 and I am always adjusting the SDS speed. I had started a thread about this back in November and the responses were;Power mainsweatherbeltswarm upmoving the table aroundDon't know if this helps but my 2 cents. Good luck | |
| Which cartridge do you use with the vpi classic? VPI recommends (and sells) both Dynavector and Grado carts. I use a Benz Ruby 3 with my VPI set up (not a classic though) and it is quite a performer and tracks very well. | |
| maggie SMG sounds dead I had a similar experience when I first got back into audio after 15 years or so. It turned out it was mostly me (my ears), partly my system needing to "break back in" after not being used for so many years and the addition of a power conditioner ... | |
| power condtioner Not a terribly expensive job to install a dedicated 20 amp circuit providing your existing main service panel box can accept an additional circuit. Not sure what the alternatives are other than an upgraded service if you don't have the room in you... | |
| That last micro cartridge adjustment Nrenter, I had a few other cartridges that I aligned prior to this one and don't recall having this problem (to this extent anyway) with the others. I will recheck that distance though and thanks for the heads up. Thats is one area I never did rec... | |
| That last micro cartridge adjustment Markd51, Sorry for not clarifying why I mentioned the washers. Specifically, I'm having problems with the cartridge alignment at the null points and the effective length. When I get one spot on, the other one moves. I can't tell you how many times... | |
| Woofers getting workout, but no bass oops, particular not paticular | |
| Woofers getting workout, but no bass mapman, I experienced the same problem a while back and purchased rumble filters. It took care of some of the problem but not all. In my paticular case a change of cartridge did the trick- no rumble woofer movement now. I know this is not what you... | |
| low riding Benz Micro Gold Just for the record, my Ruby 3 also rides much lower than the 5 or 6 previous carts I've owned. A bit of a pain setting it up with the Mint LP but well worth it once you get it right | |
| What VPI junction box do I have? Just curious, are you twisting the wires for anti skate? Which way did you twist the wire and what improvement did you hear? |