kr4

Responses from kr4

Anyone Ever Listen To Home Theater Thru Headphones
This is the way: http://smyth-research.com/products.html 
Looking for an audio cable for an Empire 598 table
Why not contact him directly instead of putting out another public notice?http://www.atma-sphere.com/Support/#Resources 
Case of the dissapearing Bass
Wrong position for the speakers and/or the listener. 
SUBWOOFER x OVER
The distinction is that the first will pass the signal to your main speakers after extracting the bass below 80Hz which is diverted to the sub while the second passes the full spectrum of signal to your main speakers. This applies only if you conn... 
Biamping, yes or no?
Ever notice how all threads about bi-amping, regardless of the OP's intent, devolve into contention? 
Ethernet over power electrical connection signals
I used this type of connection for several years and there seems to be no problem with anything else leaking in. My only concerns were with regard to the circuits in my apartment that would work with it as not all did.I have recently switched to M... 
5 or 7 channel amp for integra dhc 9.9
And the 9.9 is even older. ;-) 
? about Sony XA5400ES
It has a VC for the headphone jack output which should be all one needs. 
? about Sony XA5400ES
I will look at my manual when I get home but I think there is no such facility on this player. 
Perpetual Technology P3 DAC & 2 Input Sources
I doubt if there is any danger but the impedance effects are indeterminate. Try it or, as I would prefer, convert one of your sources to TOSlink or other. (Or add a P1A.)The P3 will accept "coaxial S/PDIF, optical TosLink, AES/EBU, and I2S 5-pin m... 
USING SPEAKER TECHNOLOGY TO KICK OPEN DOORS
You know - you need AC to move the magnet back and forth. But perhaps just going from zero to full voltage would be the first half of the swing. Thoughts from the more knowlegable? One way from DC. (Think of the AC signal as alternating DC.)You ce... 
How do you hook up ekwal speakers?
Front preouts for L/C/R go to the emotiva via RCA-terminated interconnection cables.Corresponding speaker outputs go to the front 3 speakers with standard (two-conductor) speaker cables.Of course, it is not clear from your post whether you have mo... 
Weird question re: balanced connection
Possibly if you also reversed the polarities appropriately on the speaker outputs.Of course, you can just use a Y-connector. 
What's your oppinion on bridging two channel amps?
If you have it, try it and decide for yourself. 
rewiring preamp will it work
Right. However, that does not obviate my concerns about overloading the output stage.