kennythekey
Responses from kennythekey
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Eric,I have been conjuring up a number of solutions for my mono blocks that may include the isolation pods underneath. What my dealer sometimes uses at shows, is Shun Mook diamond resonators below, mpingo discs on top of transformers, and the tube... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Bdp24,I'm not sure about my main speakers for the Bars, because I have no room to the side of the speakers for an extended pod. And, both of my speakers are bordering walkways. When I first placed the subs on the Bars, and I wobbled them around on... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Bob (gdnrbob) - I didn't want to miss thanking you for your Townshend recommendations as well!Kenny | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Okay, everyone. Back to real world results, because that's what counts, right?John, Geoff - Thanks, for chiming in on my rack stabilization post and pointing me to floating isolation. In particuar, the Townshend isolation products.My isolation bar... | |
Power Cables and Power Conditioner JbuhlWhen I moved from a home with crappy power to one with good power, my PS Audio regenerator displayed steady voltage and low distortion. I ditched the regenerator and could not be happier.If your power is clean as you have mentioned (measured?... | |
Outlet Your power is critical as this is what feeds your system. If you will be staying put where you are and can work on the electrical with a licensed electrician, much can be done. First analyze your entire situation and plan things out for the big an... | |
MRI grade vs Hospital grade electric outlets Al Porter's Porter Ports are a solid and reasonable choice. - IMOhttp://www.porterhouseaudio.com/Porter-ports.htmKenny | |
Rack stabilization alternative to lally columns and beam? kavakat1,Thanks, and you are correct, but I was looking for an alternative because the access to my crawl space is from the ground floor down and the crawl space is shallow. So, I simply don't have enough room to get a beam down there. I would hav... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Mains,After, I stabilize my rack, I think my best approach is to isolate my speakers and especially my subs in the beginning. Then, go ahead and better isolate my equipment.I had checked out the Townsend website due to this post, and sent an email... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? GeoffkaitThis of course means that in order to escape at least some of the seismic type vibration one needs to decouple from the physical surroundings entirely, including walls. Furthermore the effects of seismic type vibration don’t necessarily m... | |
Amps from the 1980's -- What gear holds up sonically? Reliably? What got me interested in many of the amps mentioned above, was GAS (Great American Sound) of the mid to late seventies. It was their Ampzilla that moved me from Sansui over to the higher end, where I would later discover Threshold and Mark Levins... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Thanks, toddveronne. The title of this post included general isolation, so why I threw my rack into the mix.The wall is a bearing wall that sits on the foundation wall, so it's not wiggly! The rack can only rock forwards and backwards, so much mor... | |
Theta Data basic transport Blue light? That's the main power LED. Lights when main power switch in back is on. Theta recommended leaving it on, while the Standby switch in front powers down the display and other circuits. They also recommend turning the main power switch off when going... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? Thanks, guys. If we can take a brief moment to get away from the springs, my bouncy floor can cause foot falls that can cause my rack to slightly wobble. If I throw a party, forget about it!Without moving the rack, I want to tie the top rear outsi... | |
Has anyone had experiences good or bad with speaker isolation or isolation in general ? geoffaitThe ride would be chaotic and bumpy, but not bumpy like a washboard, bumpy like an aircraft going through heavy turbulence, a series of unpredictable lurches up and downSo, is this why we hear reports of tonearms actually jumping up and do... |