128x128

atmasphere

Responses from atmasphere

Best arm for Dr. Feickert Analogue Firebird Table
Stringreen, not so much! Keep in mind in her recordings she was singing into a microphone, while with recording a violin the mics would likely be placed to create a stereo image.We had a setup in our room that allowed her to sing into a microphone... 
electrovoice EV Patrician 700
I've always wanted a set of Patricians. No place to put them as I have a set of Classic Audio Loudspeakers right now. The speaker is collectible because it is an excellent speaker. 
compact tube amp and in wall speaker
I would not go with ESLs if you plan to mount the drivers in the wall!!Instead I would get my hands on the most efficient and wide range speakers I could. ML ESLs are traditionally not very tube friendly and it sounds like you are on a budget so a... 
Solid state power + tube pre or visa versa?
it's more likely that the high input sensitivity of some ss amps might make the high output of some tube pres volume controls so sensitive and restrictive to become a hindrance.This statement is false. What is true is you have to be aware of how m... 
best transparent pre amp
Actually the idea that a passive is more transparent is a matter of dispute. You have to keep in mind that a well-designed and built active will have distortion that is a tiny fraction of what it is in a power amplifier! A passive has no distortio... 
Atma Sphere M60 owners......
The driver tube position in the M-60 requires either a -GTA or -GTB style of 6SN7. As you face the front of the amp:In the MkIIIs and later this is the position that sits by itself in the front.In the long chassis MkII.3 it is the rear 6SN7.In the... 
Best arm for Dr. Feickert Analogue Firebird Table
We ran that turntable at the Munich show using the Triplanar with excellent results!Lyn Stanley was singing in our room and we did lots of comparisons to her singing live as opposed to on the LP. A real testament to the amazing abilities of the LP... 
best transparent pre amp
We have a customer that did exactly the same thing by replacing his Ref 3 with our UV-1 preamp (line stage only version) and he said exactly the same thing. It gave him some pause as the UV-1 line stage costs about the same as the Tortuga; I think... 
Transitioning from SS to tube amplification
An excellent speaker to consider is made by Audiokinesis, the Zephrin. It is easy to drive and very revealing.As you are no doubt aware, dollar for dollar tube power is more expensive than solid state (and even in the 1960s cost/profit was the mai... 
best transparent pre amp
George is correct in that if a preamp imposes a coloration a passive control, even a very inexpensive one might be better.It's not cast in concrete though- passives have problems of their own that have been expounded upon a lot over the years, jus... 
Super Noisy Phono Pre--Help?
Sounds like Lewm and Jmmorford both have the same problem, and in both cases no evidence whatsoever that the preamp is at fault.If getting a lot of motor noise the culprit likely has something to do with the tone arm wiring. Perhaps a bad ground s... 
amp power & driver sensitivity in multiamp setup
PHY is a French manufacturer too...'Taps' are the outputs of an output transformer. A tap is a connection into the winding of the transformer that allows for a different impedance. Usually a tube amp has an output for 4 and 8 ohms, possibly also 1... 
Thought on OTL tube amps
I read the patent many years ago. I suspect Al has too.The transformer is impedance matching. It is air core, as it is operating at RF frequencies to modulate the output of a switching power supply. The output of the switching supply then has its ... 
Thought on OTL tube amps
The fact that the Berning amplifier (while an outstanding and very innovative design) does not fall within the definition of an OTL is something that has been put to bed many times. While I respect David as one of the top designers in the audio wo... 
Single vs Dual Power Transformers
If a single power transformer is used, are separate secondary windings for each channel used in all stereo amplifiers or is this configuration in the dual mono or partially dual mono camp? I'm just trying to understand why some manufacturers hype ...