room treatment effectiveness

Often the only way to decide after making a 'best solution' decision, is to try it. Find a dealer that will give you a return without stocking deal, or better yet maybe a loaner, that will take the stress out of the decision to move ahead.

In my opinion it strongly depends on what you are trying to accomplish and the problems that exist before beginning. My expience for best results is in addressing a very lively room with excessive echo/reverberation. This can be done with both application specific sound treatments, but frequently can be performed just effectively with some careful and tasteful decorating.

You comment specifically on a pronounced boom at a very specific frequency and report that their single solution only affected the "boom" by 0.5 db. What was the measuring of the "boom" to begin with? What other approaches did they pursue - speaker placement, listening position, toe in, etc. . . To me, it is not the end of the world having a slight excess at certain frequencies as achieving a perfectly dead flat room across the frequency range is near impossible/difficult and liveable at the same time.

I agree with Tiger but with a little twist. What exactly is it that you want to change? You wouldn't have asked the question if you didn't have an issue or two. Is it a bass issue or sound stage? Please provide more information because there are some relatively easy and inexpensive DIY treatments you can do on your own...all you have to do is purchase them and if they don't work, just return them.

My new speakers (ESP Boshran SE) produce an energy excess of 11 db at 200 hz in my room. The only placement that lowers this figure is with the speaker 8 inches from the wall and then there is no sound stage. The speakers are a sealed box design with two mids, two tweeters, and two bass drivers per speaker plus they are taller and wider than my B&W's.

I borrowed a Rives PARC and used a 7db cut at 195hz with a 3.8Q that worked well. If I can do the same thing with room treatment or make an appreciable improvement I would rather do that. Otherwise, I need to buy a PARC or bail on the speakers.

My old speakers which I set back up over the weekend are B&W N802's and they don't exhibit any response peaks like the ESP's. It is obvious from listening that the two different speaker's power response into the room is very different.

Would room treatment be beneficial for the B&W's if they stay? They certainly would not benefit from a PARC. I am contemplating my next move.

Do a drawing of your room with dimensions, furniture placement, etc and post this question on the Room Acoustics forum sponsored by Rives Audio. They will answer just about any question and are extremely helpful.

You really need to apply a methodical approach to treatment, otherwise you are simply shooting blind and and results, good or bad, will likely resemble that.

BTW, have you measured response with your listening position moved forward or backwards a few inches to a foot or so?