New expensive power cord for amp and no change in sound?

You're one of the few who are not dealing with expectation bias and realize there is no objective difference between power cables and I applaud you.

I really wish all of us would try before you buy. I understand that there is not always a brick and mortar audio store near you but there are several places like The Cable co, Music Direct, and ESP power cords that will let you return the item within a time period. It is usually true that you should start upstream first. That being said. If a power cord made no difference over the stock (black test power cord) made no difference then something is wrong both with the amp and the system. I have done a ton of testing of power cords on several systems and specifically certain components. They all make a difference over the stock power cord. The question is was it good or bad according to you. I have tested several Pass amps in my system along with several other brands. The power cord always, and I mean always made a difference. From a basic AQ NRZ to high end Kubala Sosna, Nordost, ESP, and several others old and new. If it didn’t please tell us your complete system and the brand of the power cord so others won’t make this mistake or can disprove your findings. Also, As a side note. Did you break in the  power cord. Some only need about a week or two and others need about a month. A great trick is to buy the c13 adapter to turn your power cord into an extension cord. Then use it as an extension cord for your old desktop computer, DVR, or your refrigerator which all use a lot of power. After a week or two you can finish off the final break in on your audio system. 

Think about it.  Power cords make a difference if:

(1) they are too high gauge or have cheap insulating materials or are otherwise garbage;

(2) you have a device that is spitting out interference that is picked up by the cord; or

(3) the device itself is spitting out interference and using the cord as a transmitting antenna that is picked up by other equipment.

Assuming you're not using a WalMart cord to begin with, you probably have enough space between your wiring or have an amp that is not transmitting junk. So an over-protected cord is not needed.

With one exception (the phono cord), I have found that careful wire routing (leaving space, have wires cross at 90 degrees) and using balanced interconnects eliminates interference.

(The phono cord being the exception due to the weakness of its signal and position at the very top of the chain, making it extremely vulnerable.)

And, yes, I have a very resolving system and good ears.

Really? Let be logical here. Honestly I have not tried an expensive power cord in my system but all I can say is that if cables does make a difference, it would probably be in IC. Power cable would be the last chain and the least priority. We to realize that all is carrying is power and nothing else. Yes I said it.