Why Do Cables Matter?
To me, all you need is low L, C, and R. I run Mogami W3104 bi-wire from my McIntosh MAC7200 to my Martin Logan Theos. We all know that a chain is only as strong as its' weakest link - so I am honestly confused by all this cable discussion.
What kind of wiring goes from the transistor or tube to the amplifier speaker binding post inside the amplifier? It is usually plain old 16 ga or 14 ga copper. Then we are supposed to install 5 - 10' or so of wallet-emptying, pipe-sized pure CU or AG with "special configurations" to the speaker terminals?
What kind of wiring is inside the speaker from the terminals to the crossover, and from the crossover to the drivers? Usually plain old 16 ga or 14 ga copper.
So you have "weak links" inside the amplifier, and inside the speaker, so why bother with mega expensive cabling between the two? It doesn't make logical sense to me. It makes more sense to match the quality of your speaker wires with the existing wires in the signal path [inside the amplifier and inside the speaker].
I am afraid his thesis / write up was AI generated. Otherwise known as a "bot". You are wasting your time.
|
| Post removed |
because in my experience over many years, i have found that very expensive cables don’t out-perform well chosen, reasonably priced ones That is true for any component of an audio system. Why make it sound like it is the case only for cables? You have some really nice gear so I believe you. On the other hand, there are many paths to stereo fulfillment.
|
